This is for a 2wd 95 v6 Rodeo. I DO NOT KNOW IF THEY ARE THE SAME. Remove fan shroud, fan, and belts. Get a 15/16 socket and remove the nut that holds the crankshaft pulley on and remove the pulley. You really need to get a Haynes or Chilton manual cus this part has to be done right or you are letting yourself in for all kinds of trouble. Remove upper and lower timing belt covers and make a diagram of where the bolts go, as they are not all the same. You MUST align the marks on both the camshaft pulleys with the little dots on the timing belt covers.(at 3 o'clock)This should align the key on the camshaft pulley with the hash mark on the inside cover(at 3 o'clock also). Remove the two bolts holding the hydraulic belt tensioner in and remove it. You will need to compress it in a vise and put a nail thru the holes in it to be able to reinstall it. Then slip the timing belt off. Be SURE you DO NOT move the pulleys out of alignment. The water pump is in the top center of the block, has 11 or 12 bolts in it. Remove it, clean the gasket area and replace it. And then reassemble. It is not easy, and I had a Haynes manual to help me.
How much oil do I put in a 1996 Isuzu rodeo
It has a 3.2 v6 4x4
The AC low pressure valve on a 1996 Isuzu Rodeo is located in the back of the engine compartment. The valve is on the larger of the two hoses that run from the evaporator to the compressor.
Same as any other car its located under the car attached to the engine
5 with new filter
This video should explain it: http://www.youtube.com/watch?v=TWVg-YmTw2A
Down Rodeo was created on 1996-11-16.
Yes.
It is behind the timing belt coves and you will have to take the timing belt off to change the water pump out
how do you find out how to check the transmition in a isuzu rodeo
Blue Rodeo - 1996 TV is rated/received certificates of: Argentina:13 Iceland:L
How do you replace the water pump and where is it located on a 1996 Buick Skylark V6