Water Pumps
2000-2005 Dodge & Plymouth Neons
Daewoo Nubira
VW Jetta

Where is the water pump located on a 2001 Daewoo Nabira 4 cylinder?

454647

Top Answer
User Avatar
Wiki User
2006-09-18 14:32:37
2006-09-18 14:32:37

The Water pump Is in the most retarded spot I've ever seen one be (at least it was on my '99.) Your going to have to take off the front passenger side tire to get at it. its underneath the timing belt cover. I suggest you get some sort of manual to help make sure you dont mess up the timing and bust a valve. You can get a PDF format manual on this site : http://autos.groups.yahoo.com/group/daewoo/files The water pump itself is in the bottom portion of the engine. You should be able to see it once you take off the tire and the timing belt cover. Good luck cause this job almost made my head explode (It Didn't help that Partsource gave my the wrong water pump!!!!)

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

It depends on which of them. The one for coolant is located in the water inlet. Ambient temperature sensor is located in the filter box.

User Avatar

open the upper timing belt cover the first thing lower to crankshaft is water pump.

User Avatar

The water pumb is driven by the timing belt. When looking at the front of the car, the front of the engine is on the left. The water pump is located at the bottom left of the engine.

User Avatar

Water Pump LocationLocated in the V of the cylinder banks, driven by the timing belt.

User Avatar

The water pump is located on inside of the timing cover. It is driven by the timing chain.

User Avatar

The water pump on a 2001 Nissan Pathfinder is located in next to the engine. It is on the passenger side of the cylinder block.

User Avatar

The temp sensor is located on the intake manifold

User Avatar

Under th inlet manifold, you will need to remove the alternator to gain access

User Avatar

On the 4 cylinder engine it is located in the water neck where the hose from the radiator goes on the passenger side of the engine.

User Avatar

It's located on the left side of the motor its the pulley in the middle i think and its pretty small compared to some of the other water pumps ive seen

User Avatar

With an indirect water heating system and cylinder, the water that circulates around the boiler, pipes and radiators is kept totally separate from the stored water in the cylinder that is used for bathing. From the outside the indirect cylinder looks identical to the direct cylinder save from two additional pipe connections on the side of the cylinder. Inside the cylinder a coil heat exchanger is installed, which allows hot water from the boiler to flow into the upper connection and leave at the lower connection to return to the boiler for re-heating. The hot water in the coil indirectly heats the water in the cylinder. A Direct Cylinder is heated by a source located within the cylinder - such as an electrical immersion heater. Because the Immersion Heater is heating the water 'directly' the cylinder is called a 'Direct Cylinder'. In a direct cylinder there are no other external heat sources.

User Avatar

if its a 4 cylinder, its located inside the timing case.

User Avatar

The thermostat on a 2001 Nissan Frontier 4 cylinder is located on top of the water pump. The thermostat can be found by following the upper radiator hose.

User Avatar

Right side if the cylinder block under the polastic cover.

User Avatar

If the engine is the 4 cylinder the pump is driven off the timing belt. It is located behind the timing belt covers.

User Avatar

Should be behind pulley directly above crankshaft

User Avatar

The water jacket is on the out side of the cylinder and in side the out side casing. If you are wanting to know what is in the water it is anti freeze.

User Avatar

When you change the water pump on 2003 Chrysler Sebring six cylinder, you first need to purchase the correct replacement pump. You will need the right tools including wrenches to remove the old pump that is located on the cylinder block in the engine.

User Avatar

It is located behind the timing belt cover and is driven by the belt. There are many steps to get to it so it is best to get a manual and do the timing kit at the same time

User Avatar

It is the sensor located in the water pump. It is a 2 prong plug, screwed straight into the front of the water pump. The other sensor that is located in the cylinder head is for your gauge.

User Avatar

if you dont know how to change out a water hose your an idiot!!!!

User Avatar

The water pump is under the timing belt cover on the passenger side.

User Avatar

for 4.0 liter engine it was located at the upper water outlet pipe above the water pump


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.