It is in front, on the passenger side, at the bottom of the windshield washer tank. Your acces to is from the front passenger wheel under the plastic cover thatis all around the wheel. Unclip thefake-plastic screws, mostly the one close to the tank. Once you've locate the reservoir and the pump,unplug the electrical harness and the small pipe and then pull it by the upper side with a flat screwdriverand it'll come easy...It's just a snap-on pump with a rubber piece around that make it thight around the plastic pump.
It could be the ICM or the pickup module.
Not easy!!! Get a manual on your car and it will help on the next repair.
what is your ?, a MAF is basicly a IAT The Mazda Protege and Protege 5 2.0L engine has an IAT Sensor located just past the factory air filter box. It is a two wire sensor that plugs into the intake tube via a rubber grommet. The three wire plug in the Mass Air Flow Sensor. DO NOT Unplug either of these sensors while the vehicle is running or key turned to accessory. Will cause a flag in the computer and turn on the Check Engine Light. Hope this helps.
It means there is bad/no connection between the car's computer and the oxygen sensor after the catalytic converter.
A bad battery terminal(s) connection, bad ground, bad ignition switch, bad starter.
The fuse located inside (driver's side) #13 is responsible for it.
the fuse is located inside the passenger compartment in the fuse box close to the hood release latch-20 amps
If it is clogged use a fine sewing needle (needles come in different thicknesses)to open the hole..use washer to force clog out.. also try a cotton ball soaked with ammonia to soften the clog..
i put a new windshield wiper moter in and the fuses are fine but my wipers still wont work
It is mounted at the windshield washer tank outlet (on the bottom of the tank). You need to remove the tank from its engine compartment mounting to gain access.
At the top of the engine near the windshield on the passenger side.
Drain the water from your Mazda Protege radiator. Remove the hoses from your radiator. Remove the radiator stabilizing arm. Remove the radiator retaining bolts. Reverse the process to install the new radiator.
You can use the end of the tire iron to remove the lug bolts off a 1999 Mazda Protege DX.
Like any other wheel?
Were is the egr valve on a 99 Mazda progege 1.8
get the proper one for a Mazda
When you remove the caliper, the pads can be pressed out by hand.