Should be firewall area by booster.
The brake controller wiring harness connector for the 2005 GMC Envoy is located under the dash on the driver's side of the vehicle. Look for a connector plug not connected to anything, next to the hood release latch.
The diagnostic connector is along the wiring harness, under the hood, on the passenger side firewall.The diagnostic connector is along the wiring harness, under the hood, on the passenger side firewall.
It depends on which Harness you are looking for.
There is a lights control box under your steering wheel.
The way to plug in the harness depends on the type of harness that you have. Some are designed to unplug a connector then insert the harness inline with the wiring. Some require a special connector that clamps on the side of the wires, while others require wires to be cut and spliced together.
I have a 1994 E150 Conversion. But the factory harness is located under the rear of the van to the left hand side and attached to the frame.
I have a 1994 E150 Conversion. But the factory harness is located under the rear of the van to the left hand side and attached to the frame.
What you need is an alternator wiring pigtail harness from the dealer!
The C115 sensor is located right above the wiring harness in a green clip.
Open the hood and look at the firewall area at the left rear of the engine compartment. There should be a large multi pin connector and a single pin connector hanging from the wiring harness near the a/c drier.
The diagnostic connector is under the hood. It is located along the engine wiring harness.
A 1991 Dakota is not OBD2 compliant. It is OBD1, and the diagnostic connector is under the hood on the wiring harness on the passenger side firewall.A 1991 Dakota is not OBD2 compliant. It is OBD1, and the diagnostic connector is under the hood on the wiring harness on the passenger side firewall.