Dodge Intrepid

Where is transmission input and output speed sensors located on 2002 Dodge Intrepid?

567

Top Answer
User Avatar
Wiki User
Answered
2012-04-06 01:58:26
2012-04-06 01:58:26

where is the input and output speed sensors located on a 2002 Dodge Intrepid?

is that way the speedometer don't work?

Read more: How_many_and_where_are_the_input_and_output_speed_sensors_located_on_a_2000_Dodge_Intrepid

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


the input and output speed sensors are on th driver side of the transmission located one on each side of the dipstick


The input sensor reads the speed of the transmission input shaft.The output sensor reads the speed of the transmission output shaft.The transmission computer uses these sensors to help time the shifts, and to run the speedometer.The input sensor reads the speed of the transmission input shaft.The output sensor reads the speed of the transmission output shaft.The transmission computer uses these sensors to help time the shifts, and to run the speedometer.


There are two speed sensors, an input and output. They are located on the transmission. If the problem is the speedometer not working it is the output sensor located on the driver side of the rear of the transmission.


They are on the driver's side of the transmission, and require a 1 inch deepwell socket to remove, and you may need some extensions to reach it.


The three sensors are [input sensors] that are wired to the Transmission Controller to give speed information to the Controller for proper shift points,[up-shifts-down shifts Input Turbine Speed.... Output Turbine Speed.. Vehicle Speed sensor...


There is one of each and they are located on the left (or driver's side) of the transmission. The front one is the input sensor right by the dipstick tube, and the rear one is the output sensor. Must be careful when tightening the new ones since the are plastic.


They are the two wire sensors screwed into the front of the transmission case.


The Vehicle Speed Sensor will be on top of the transmission, at the transmission output. Wheel Speed Sensors will be located at each wheel.... the latter are for ABS.


They read the speed of the input and output components of the transmission.


It is on the output end of the transmission.It is on the output end of the transmission.


The input and output speed sensors are the two wire sensors on the front of the transmission case. The input is closer to the engine.


There are two sensors located on the driver's side of the transmission. there is an input and and output sensor. You can get to them from the underside of the car.


AnswerTry replacing the input and output speed sensors located on the left side of the tranny and reset the computer. They will run around $40 to $50.


Input Speed Sensor is on Front of Trans closer to the engine. Output is on the front, farther to the drive side. Both are two wire sensors.



I have a 1999 sebring and i had to replace my speed sensor. there are two sensors one located on the transmission that's the internal one and the other one is just off the drivers front wheel well, you have to pull the tire off.On the transmission, there are two,one input and one output. If the speedometer operation is the problem the output sensor is the problem is located on the driver (Left)side of the transaxle.


The input and output speed sensors are on the front of the transmission case. Both are two wire sensors. The input is closer to the engine.


The abs wheel speed sensors are at each wheel bearing. The transmission has an input and output speed sensor mounted on the front of the transmission case. The vehicle speed signal comes from the transmission computer via the output speed sensor.


The NAG1 transmission uses the wheel speed sensors (at each wheel bearing) as the output speed signal.


The vehicle speed signal comes from the transmission output speed sensor.


They are the two wire sensors screwed into the front of the transmission case. The input is closer to the engine.


They are the two wire sensors on the front of the transmission case. The input is closer to the engine.


Is located on the back of the transmission. The output sensor is contained in a rectangular box. The sensor should be labeled as such.


These are typically located at the top of the transmission output.


If it has a 4-speed transmission, it has 2 speed sensors, one for input speed and one for output speed, located on the front of the transmission. If it has a 3-speed transmission, it is located under the vehicle on the back of the transmission, where the passenger side CV axle goes in, to the left of the inner joint.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.