answersLogoWhite

0


Best Answer

Take plastic panel off under stearing column (4 screws - two holding on hood release). There's a metal panel behind that (take off 5 small bolts). It's to the left of the stearing column. could be blue or yellow with 5 wires coming off it. It slides off a plastic attachment. I Know it says in the manual it's to the right of the stearing column..........but not always.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

15y ago

I have a '98 Explorer, and the flasher is located behind and above the cover to the emissions diagnostic connector. This cover is to the left of the hood release. You can't get to the flasher via the cover. You have to look/reach underneath the bottom end of the dashboard. Maybe the '97 flasher is in the same area. In the 97 Ford Explorer the flasher unit is directly behind and above the OBD 2 dignostics connector it is yellow and mounted with two plastic fasteners to a bracket it will have one additional male connector than an aftermarket replacement flasher which is not used so an aftermaket unit will work fine just tie wrap it back to the original bracket.

This answer is:
User Avatar

User Avatar

Wiki User

14y ago

It is incorporated within the hazard flasher switch. If this switch is malfunctioning, try the WD-40 fix before replacing it. Spray WD-40 around the switch and pop it up and down a few time and wiggle it around a bit. This will fix problems most of the time. There is no separate flasher unit as you may remember in older cars. The flasher is incorporated within this multifunction switch. turn signal flasher is located in the fuse panel fuse panel is in dashboard below a/c vent on left side of truck

This answer is:
User Avatar

User Avatar

Wiki User

18y ago

I have a 92 Ford Ranger also and mine is located on the top of the steering wheel.

This answer is:
User Avatar

User Avatar

Wiki User

11y ago

It's behind the glove compartment door in a box you need to remove the cover and it's inside.

This answer is:
User Avatar

User Avatar

Wiki User

15y ago

Under the dash, in the fuse panel. It's the big round one.

This answer is:
User Avatar

User Avatar

Wiki User

15y ago

In your fuse panel - under dash - drivers side

This answer is:
User Avatar

User Avatar

Wiki User

14y ago

#22 - 10 amp fuse - Turn Signals ( in the fuse panel on the drivers end of the dash - the plastic removable fuse panel cover is visible with the drivers door open )

This answer is:
User Avatar

User Avatar

Wiki User

10y ago

The Blinker fuse is located in the dash behind the driver side speaker. Remove the cover, remove the speaker and it will be located on the left about six to seven inches into the dash

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the turn signal flasher on a 2001 Ford F250 Pickup?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Movies & Television

Turn signal relay location on 2000 ford 250?

turn signal relay on 2000 f250 diesel


How do you replace 2001 ford f250 front turn signal bulb?

would highly recommend a trip to your local parts store, they have manuals that are model specific and have a wealth of info in them 1 remove passenger side headlight assembly. Remove the black plastic protector over the headlight assembly. Next remove the headlight assembly. This is done by lifting up on the left and right side retaining clips at the back of the headlight assembly. Black spring steel clips. They may be rusted and a little WD40 can help. 2 once the clips are lifted, the headlight assembly can be pulled forward. Now you can see the 2 retaining screws on the side marker light lens. Remove these and pull the marker assembly forward. Pull straight out, there is a retaining pin that need to come straight out. Now you can turn the light holder a quarter turn counter clockwise and replace the bulb.


How do you bypass the electronics on 1991 f250?

You're really not going to - those electronics are needed in order for the vehicle to operate. The only way you'll do away with the engine ECM is if you remove the fuel injection and replace it with a carbureted system.


How do you fix the dash-lights on a 2006 f250?

First, sheck if your fuse is working after that see if any of your sterio cables are touching and if they are separate them and put black tape and then pop your hood and see if the tail light fuse is working and if its no change it. that what i did and it work on mine. I had all the lights on my dash go out and discovered it was the dimmer swith. The connection had become corroded and I was able to replace it with one from the local Pick-n-Pull for $2.99. My local parts store said it would be $102.50, not including tax, IF they could get it. Best of luck to you!


Related questions

Where is the turn signal flasher located on a 1973 ford F250 pickup?

The 1973 Ford F2 50 pickup truck turn signal flasher unit is located behind the drivers side dashboard. The turn signal flasher unit will be near the back of the speedometer.


Is there a signal flasher and a hazard flasher on a 03 F250?

Yes, in the panel under the dash.


Where is the 2005 f250 turn signal flasher relay?

The turn signal flasher relay on a 2005 Ford F250 is located under the dash near the brake pedal. It controls the pulsation of the turn signals.


Where is the turn signal flasher on a 2000 f250?

The flasher is a little silver like tube and is located under the driver side dash in the fuse box or it will be hanging from a wire and you just pull it out and plug in a new one, that simple.


Why do emerg ency flashers work and the turn signals wont blink on 97 f250?

The emergency flashers and the signal lights are separate systems. Each has it's own fuse, switch and flasher relay. If your turn signals light up but don't blink I would blame the signal flasher relay.


What is the 2003 ford f 250 fuse panel lay out?

Sometimes my turn signals stop flashing. I can.t find the flasher in the fuze panel. Please tell me where to find the turn signal flasher on my 2004 F250 Superduty Ford.


How many tons can a standard ford f250 pickup truck carry?

a standard f250 pickup is a 3/4 ton pickup,so the weight would be 3/4 of one ton


Is ford f250 superduty a half ton?

f250 superduty is a 3/4 ton pickup


Can you pull a 4500 lb horse trailer with your 1993 Chevy Silverado Pickup?

I've pulled a 20,000lb trailer with my 2001 ford f250, so i cant see why not.


Where is the multifunction switch on 2004 f250?

On a 2004 Ford F-250 : The multifunction switch is INSIDE the steering wheel column cover ( the turn signal lever and the hazard flasher button sticks out of the steering column cover )


Where is the flasher relay on f250?

Would help to know what year. Without the year I cannot answer.


What is the oil capacity 2001 ford f 250 power stroke?

2001 FORD TRUCKS F250 HD PICKUP 7.3L 8-cyl Engine Code F TurboDiesel = 15 Qts W/Filter Hope This Helps.