answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2006-07-28 14:57:58
2006-07-28 14:57:58

It depends on whether the distributor has been replaced or removed, and whether they put it back the same way. In any case, #1 is wherever the rotor is pointing when #1 is at TDC of compression cycle.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The left bank is 1,3,5,7 and the right bank is 2,4,6,8. The distributor turns clockwise.


how to repace the distributor on an 98 chevy silverado




If you remove the distributor cap and rotor you will see it bolted to the plate and it will have electric wires pluged into it. It will be on the right side of the distributor.


Align the rotor with the number one position on the distributor cap, then with the engine at TDC insert the distributor. There may be a mark on the outside of the distributor to help.


what is the distributor setting for a 1996 Chevy blazer


how reinstall a distributor on a 1998 chevy astro, and faun time


Look at the back of the intake where the distributor is. Now look behind the distributor and you will see it. it is about 3 inches long with a electric wire pluged into it. It is alittle tough to get to.


Yes, a 1997 Chevy Cavalier does have a distributor cap. The distributor does not have points and a condenser. This part is one electronic unit.


I would replace the module in the distributor. Take the distributor cap off and it will be the idem that has 2 small screws that hold it on the base of the distributor, and it will have electric wires that hook to it. The module controls the fuel and fire.


how do you remove and replace the distributor cap on a 97 chevy cavalier?. I can not get to it.


Standing in front of the vehicle with the hood open, looking at the distributor, number 1 on the distributor cap would be at the 6 O'Clock position.


Standing in front of the vehicle with the hood open, looking at the distributor, number 1 on the cap would be at the 7 o'clock position.


For a 1985 Chevy S10 with a 2.8L engine the firing order is: 1-2-3-4-5-6 The Distributor rotation is clockwise.


It will be right behind the Distributor, and screewed into the top of the engine block. It will have a electric wire pluged into it.


where does the hot wire come from going to the distributor on a chevy 350


The number 1 cylinder is located at the front left of the engine block while FACING the engine. Follow the spark plug wire to the distributor a POW there it is.


No the distributor gear that is on the end of the distributor is to small for the big block cam shaft.


replace the electric part under the distributor costs nothing at a junk yard


restabbing distributor and setting time I'm replacing 4 cylinder motor in a 87 Chevy s10 how do I install distributor and get the truck in time



The 93 Beretta does not have a distributor, it has coil packs.


There are two screws that hold it to the distributor.


No, it has coil packs, there is no distributor.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.