I believe there's not a cable as such, as it's all electronic and wired. Correct me someone please if I'm mistaken
its electronic. No cable
On a 1995 Ford Ranger : The ODOMETER is near the center of your speedometer
how do i replace a throttle cable on a 1988 ford ranger pickup
1996 ranger does not have speedo cable it is electronic
You can replace the speedometer cable, on your 1988 Ford Ranger, by loosening the cable nut on each end of the cable. The cable will come off and can then be replaced.
Yes , I BELIEVE the last year for a speedometer cable on a Ford Explorer was the 1995 model year so the 1991 Ford Ranger would definitely have a speedometer cable
It is! against the law in ALL 50 states to turn an odometer back, or reset it in anyway.
I believe that was started with the ( 1998 ) model
I believe that 1995 was the last year for a conventional speedometer cable on a Ford Explorer , and then Ford went to an electronic speedometer with a vehicle speed sensor
my ford 2001 ranger had the same thing happen to me i sent to the ford delear for repair and it was a missing fuse so check all fuses
grab the broken end of the cable with vice grips and pull it
I have no clue... I need help on that too...
battery cable connection , dead battery
On a 1997 Ford Thunderbird : The odometer is in the middle of the speedometer
the odometer is driven by a tiny electric motor now what fails on this is tha rubber worm gear now the only way to fix this problem is by buying a whole new spedometer cluster which runs about $300 from ford
It should be attached to the short positive battery cable.
Unhook the negative battery cable for 15-30 min
Disconnect the negative battery cable for 30 minutes.
Your speedometer may have failed, or the speedometer cable that connects to the transmission, or the plastic gear in the transmission may be broken.
A diagram of what component?
can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?
Probably at the rear lower end of engine--follow the + battery cable
connect it to the starter mounting bolt underneath.
There should be a screw near the end of the throttle cable on the throttle body.
If it's a stock transmission, the shift linkage is mechanical.