answersLogoWhite

0


Best Answer

We installed a 24' doughboy last year. It "wintered" well in our cold climate (northern il). Our grade was approx."1 in 3"...one wall began to indent badly this last week due to heavy rains and water trappage against wall. we had to dig down to within 1 1/2' of bottom of pool,install drain tiles (with holes)around that side. after digging the wall down,the wall dent "popped" back out. hope that helps you. We completed the installation of an 18x33 above ground in this manner last summer. I would recomend that you excavate 2'-3' beyond the pool wall and slope the side of the excavation so that the earth does not come in contact with the sidewalls. We installed a deck between the pool and the slope, creating a level walk out to the pool, and hiding the excavated area.

User Avatar

Wiki User

โˆ™ 2005-04-27 19:14:26
This answer is:
User Avatar
Study guides

What is a balance equation

Is hair perm lotion an acid

How do you adjust the pH level of pool water

Is shampoo an acid or base

โžก๏ธ
See all cards
3.94
โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…
16 Reviews

Add your answer:

Earn +20 pts
Q: Where the grade of a yard drops off significantly could you dig out a concave area and install an above ground pool?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you install water return fitting on an above ground pool?

To install the water return fitting above the ground pool, you have to switch off the source. After this you can then install the water.


How do you install a gas heater for an above ground pool?

You install it underground...


Can you install an above ground sand filter on a in ground pool?

Probably not going to be adequate.


How do you install a ground wire to an above ground pool?

Do not hesitate. Calla qualified electrician now.


How do you repair an above ground pool filter?

Install a new filter


Where can you find above ground pool repair in your area that install's liner?

Do a goggle search find above ground pool repair k


How do you install an above ground pool?

To install an above ground pool you will have to level the ground where the pool will be placed. You should then add a layer of sand. You should lay out the bottom rails and connect them as shown in the directions next. Install the walls, uprights, and wall bars. The liner will be installed last.


How can you level a above ground swimming pool after the pool is up and the ground was not?

Disassemble the pool, grade the site, install pool


Where can one find an above ground pool deck installation company in Indianapolis?

I just put in a new above ground pool. Is there someone in Indianapolis that can install a deck?


Pool Liner?

form_title= Pool Liner form_header= Replace or install a liner for your pool. Do you need to replace an existing liner?*= () Yes () No Is it an in-ground or above-ground pool?*= () In Ground () Above Ground What is the size of your pool?*= _ [50]


can you use an above ground pool and install in ground leaving about 1-2 feet above the ground?

Absolutely. Many people excacate and then place an above ground pool into the hole such that a foot or two stays above ground. Also make sure you either have clearance for your filter system or run the line into the ground and up to the filter as well.


How do you install a packed sand bottom in an above ground pool?

if you google - installing an above ground pool - you will get links to sites that post quite explicit directions good luck

People also asked