4x4's & p/u's have the starter harness running in back of the motor(intake manifold) down by the heater case--U might have caught the wires under the heater case or Evaporator case.
The heater core has no gasket. If it is leaking, it must be replaced.
The heater door control on a Blazer can be replaced by purchasing a new one. The heater vent will pop out with a little nudge from a flat tipped screw driver. Then insert the new heater vent door control.
The heater valve could be failing to open for one reason or another.
how do i replace a heater core in a 2001 Chevrolet blazer
how to replace a heater core in a 1997 Chevy blazer
probably the blower motor resistor
They did'NT make the Trailblazer in 2000 might you be looking for information for a 2000 Blazer.
when im stummed about my blazer i jus take it to an auto parts store an ask them where the part is im looking for or a chiltons book will work
It can be something as simple as that they are broken and needs to be replaced. Or the internal spring holding it could have worn out as well and also needs to be replaced.
were is the heater relay on1996 jimmy?
It depends on what is broken on your water heater, as to how much it would cost to fix it. It might actually need to be replaced and be more cost effective to replace it.
When you want to know when your hot water heater is broken, simply run your faucet and test the water. If it's cold, the heater is broken.
If your heater core wasn't leaking at the time your radiator was replaced , then ( no ) That would be two separate jobs
The heater core is inside the heater unit on the passenger side under the dashboard
The most likely reason that the heater control won't change the air flow is that the cable that moves the diverter valve has broken and will need to be replaced.
Sounds like the heater core may be plugged up or the heater damper door is broken. See "Related Questions" below for more
You have to completely remove the dash to get access to the heater core.
you must have low coolant or a bad heater core
The thermostat might need to be replaced. or the coolant level mite be low. it is a sign that it is. and also the type of coolant used if not flushed and replaced tends to clog the heater core. try flushing it out. lastly you have a bad intake gasket and leaking coolant out. 4.3's are notorious for this.
Low on coolant, thermostat stuck open, blend door actuator broken or stuck, plugged heater core to name a few.
The thermostat is broken and needs to be replaced. You need to disconnect the water heater until you can get it repaired to prevent over heating and a possible fire.
Heater Airbound? Heater control cable not working? Heater core plugged?
Drain the water from your 1994 Chevrolet Blazer cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
A broken fan heater can not work and A FORD Foucs does not run
You have to remove the entire dash board to gain access to the heater core.