Probably be cheaper and easier to do a service exchange. Give your old one in and get a recon one in exchange from your local motor factors. hope this helps
Rebuild the Wall was created in 2001.
You take it to a mechanic. You need to do an alignment when anything is done to the front end.
Both ends need removed.
This Joint Is Jumpin' - 2001 TV was released on: USA: 1 May 2001
Could be a couple of things: tires, cv joint, wheel bearing, or a lion.
it as simple as pulling back the cv boot and hammering the joint off. there is a retaining ring on the inside of the joint. when you put it back together just make sure the ring is in good shape.
A bad ball joint or tie rod end.
the constant velocity join is located in the front of the vehicle.(front axle) its pretty simple to replace just look at it and you'll know exactly what to do. straight forward job.
A 2001 Jeep wrangler (TJ or Limited model) does not have a CV (Central Velocity) joint. Both front and rear axle assemblies are "straight" axles; the rear has no axle joint and the front uses a standard universal (u-joint) with caps and needles (both Dana 30 and Dana 44) To replace the front driveshaft u-joint: you would need to remove the wheel and hub assembly and slide out the driveshaft through the knuckle. The u-joint is retained by press fitted caps and/or C clips and can be changed with the aid of a vise, hammer, punch or press. I visual inspection can be done to see any play in the front shaft prior to removal-the typically are very easy to diagnose-no movement within the joint is permissible (wiggle with small crow bar or large screwdriver) with wheel turned exposing the u-joint within the knuckle assembly...there may be some end to end play within the shaft movement (and up and down) but no play should be found within the joint itself.
A) Check your outboard CV joint (axle) Ryan B) Check your galiper pin if it is tight
Just had one done in Lubbock Tx. 5/17/12 everything $1643.69. 4 hours to complete. I thought it was a fair price.
replace lower ball joint on ford ranger 2001