Want this question answered?
Router(config)# line vty 0 4
router(config)#line vty 0 4router(config-line)#transport input ssh
Virtual teletype (VTY) is a command line interface (CLI) created in a router and used to facilitate a connection to the daemon via Telnet, a network protocol used in local area networks.To connect to a VTY, users must present a valid password.The VTY interface has three restricted mode commands:VTY View: Enables read-only interface accessVTY Enable: Enables read-write access to the CLIVTY Other: Includes modes like Trivial File Transfer Protocol (TFTP)VTY uses a set of CLI command actions, which depend on the three types of actions CLI can perform:MovementEditingAdvanced
vty stands for virtual terminal; it is used for connections such as Telnet or the safer SSH. The numbers 0 1 refer to a range of possible connections. Usually all possible connections on a router or switch should be programmed together, since you don't have control over which user accesses which connection.
vty stands for virtual terminal; it is used for connections such as Telnet or the safer SSH. The numbers 0 1 refer to a range of possible connections. Usually all possible connections on a router or switch should be programmed together, since you don't have control over which user accesses which connection.
The correct answer is VTY.
The router can handle as many telnet sessions as there are VTYs. The maximum number of possible VTYs varies by platform. There are 5 VTYs by default, you can add more VTYs by configuring them in configuration mode. Example Line vty 0 16 login (or any command) Once you refer to a VTY, it will be created.
router>enable router#configure terminal router(config)#line vty 0 4 router(config-line)#password cisco router(config-line)#login to configure router with telnet you must set up password or secret for privilieged mode.
Type on previllage Mode:- Router(config)#line vty 0 4 Router(config-line)#pass Router(config-line)#password 123 Router(config-line)#login Router(config-line)#exit used for telnet , to take ur PC on telnet through Router..............
telnet
router ripline vty 0 4interface fastethernet 0/1
Configure an IP address on the relevant network interface and bring it up. Configure a password on at least on vty line and give the login command.