Where is cylinder temp sensor on 2000 Ford f250 with v10 engine
It should be the 6.8 liter engine and the capacity is 6 quarts
7.3 Liter Turbo
In a 2004 Ford F-250 : Gasoline engine choices ( 5.4 liter V8 and 6.8 liter V10 ) Diesel engine ( I believe that is 6.0 liter )
You can replace the clutch master cylinder, on your Ford F250 7.3 liter super duty truck, by first removing the hydraulic line. Next, unbolt the master cylinder. Reverse the process to install the new master cylinder.
I was looking at the Ford parts website and it shows : For a 1984 Ford F-250 : ( the 6.9 liter / 420 cubic inch / 8 cylinder diesel engine was available )
Yes , the Ford 5.4 liter / 330 cubic inch V8 engine is a gasoline engine
Under the intake.
A ( 2000 ) Ford F-250 with the 6.8 liter gasoline V10 engine is rated at : ( 310 horsepower at 4250 RPM and 425 lb/ft torque at 3250 RPM from the factory )
On a 2004 Ford F-250 , 5.4 liter gasoline V8 engine : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle
'03 6.0 takes 15 quarts. '04 should be the same.
on the timing cover sensing the damper
Look at the top of the engine at the rear center
15 qts oil including the filter
Bank 2 is the drivers side of the engine on your Ford F-250 5.4
In a 1997 Ford F-250 *** LIGHT DUTY *** (YES , the 4.2 liter V6 engine was available )
Bad Plug or coil pack.
On a 2004 Ford F-250 , 5.4 liter V8 engine : Bank 1 is the passenger side of the engine
gas or diesel?
On a 2005 Ford F-250 : * For the 5.4 liter V8 and the 6.8 liter V10 gasoline engines : ( Bank 2 is the drivers side of the engine )
I own one and its 6,750 LBS
In the brake master cylinder reservoir on the drivers side of the engine compartment near the firewall