Add your answer:
Can you replace a 32-valve 5.4 engine in a 1999 ford navigator with a 16-valve 5.4 engine from a 2001 ford f150?
nope has to be the 32 valve engine
Where is the ac recharge valve for a 2003 ford focus with a zetec engine?
The AC recharge valve for a 2003 Ford Focus with a Zetec engine is near the firewall. It is the larger of the two lines going to the compressor.
How do you replace valve stem seals 1989 Jeep?
How do you replace valve stems and guides on a 1989 Jeep 4 Cylinder engine?
How do you replace an EGR valve on a 2001 Ford Taurus?
do you have the 3.0 V6 12 valve engine, or the 3.0 V6 24 valve DOHC engine? 3.0 v6 12 valve
Where is shift solenoid a located on a 2003 ford focus zts with a 2.3 l engine?
from my research its above the valve body inside the tranny and easy to replace but watch for springs
How do i replace a valve on 1998 ford 3.8 liter engine?
The head has to come off to replace a valve. That'a a pretty big job.
How do you replace the EGR Valve on a 92 S10 Blazer?
What engine???
How do you replace egr valve on 2005 focus?
Get a repair manual at NAPA and follow the instructions.
Where is egr valve located on Ford Focus?
The EGR Valve is located in the engine compartment on the Ford Focus. The EGR Valve is set almost dead center into the top of the motor. The EGR Valve looks like a small carburetor with caps on the top and sides.
Where is the PCV valve on a 2002 ford focus diagram?
Down behind the engine by the firewall.
How do you replace the engine coolant in a Skoda felicia?
Open the drain out valve at the bottom of the radiator to allow the coolant to run out. Replace the valve and add the fresh coolant.
Why does an engine valve need to be removed from the cylinder head?
An engine valve normally needs to be removed from the head for a valve job, or to replace other parts related to its operation like the spring or valve guide. This is normally done when the engine has a poor seal from the valve/valve seat or oil consumption caused by the vavle guide.
Show engine location for PCV valve 2002 Nissan Sentra?
I am looking for diagram of the engine to replace a pcv valve. 2002 Nissan Sentra 1.8
Where is the PCV valve located on 1990 Celica GT?
No PCV valve on this engine. Has "PCV system". Hose from valve cover to throttle body. Nothing to replace.
If you have to replace the valve cover gasket does it mean you have engine problems?
Not usually valve cover gaskets tend to leak after time just due to the constant temperature changes in the engine
How to replace a camshaft position sensor in a Mercury Sable?
what year, and which engine? Note: if it is newer year, there are two 3.0 liter engines, a 24 valve and a 12 valve. 2000 3.0 liter engine 24 valve
How do you replace idle air control valve on 2002 Ford Taurus?
remove it from the engine
Where exactly is the PCV valve on a 2.2 liter 1995 Pontiac Sunfire and is it difficult to replace?
When facing the engine, you'll notice two small fittings on either end of the valve cover. The PCV valve is the one on your left. Unscrew the plasic cap and replace the valve.
Why does the engine stall when accelarator is released?
Most likely it is your IAC valve - Idle air control valve. It comes out with 2 screws to replace.
How do you replace PCV valve on 2004 Ford Taurus?
The PCV valve on a 2004 Ford Taurus should be on the left side of the engine. It plugs into the valve cover at the rear of the cover.
Where is PCV valve on 2005 Ford Focus?
On the drivers side on the engine block. follow the hose that comes from the back of the valve cover. may have to remove intake manifold.
Can you replace a Ford 4 liter engine without an egr valve with one that has a egr valve?
You could transfer the upper intake manifold from the old engine to the new one one, and voila! you now have a non-EGR engine!
How do you repair a Dodge Caravan engine showing fault code P0406?
replace egr valve.
Where is the PCV valve located on a 2000 Ford focus with a 2.0 liter Zetec engine?
http://www.focushacks.com/index.php?modid=70 you have also a picture with the valve. So long!
Where is the camshaft positioning sensor located on a 2001 Ford Focus?
On a single cam ford focus 2000-2001 the cam position sensor is below the pcv valve. If looking at the engine it is on the right side, rear, about a 3inches from the top of the engine.
Get the Answers App
