Be the first to answer!
u have to pull the dash out its behind it.
top of tranny near firewall kinda centered
Behind the radio mounted to the floor board and firewall
If the water pump is bad ussually the heater will stop giving hot air .
that is a vent hose. it hangs freely. does not connect to anything.
I got a 1997 Nissan 200sx and I don't think its that much diffrent. On mine I had to lift it because you cant see it from just opening the hood. Its on the passengers side, facing the firewall. its really hidden in there. And its kind of hard to take it of.
Honda 200sx ? no such car its eather a Honda s2000 or a Nissan 200sx
I have a 1997 200sx se with a sunroof.
the horn on my '97 Nissan 200sx doesn't work. how do I fix it?
Sounds like either the windshield seal if defective or the heater core is leaking Check to see if water? is antifreeze
The starter is on the driver's side under the intake manifold. If you need additional help locating it, look for the fuel filter on the firewall and the starter will be in front and below it.
I have a 1987 Honda 200sx and it does between 50 and 55 stock
The 95 200SX S14 is OBD1 EDIT the 95 200sx 1.6Liter engine manual trans is odbII says right on the underside of the hood.
My 1996 200SX SE holds 12 gallons of fuel.
drain the radiator, disconnect the radiator hose from the water pump. disconnect the water pump. lay down the seal connect the new water pump. connect the hose back to the radiator. its pretty easy
The 200sx se-r chassis is the same chassis as the 200sx se. I have a 96 se-r and the only difference between mine and an 200sx SE are suspension differences and the engine itself.
oilk sending unit on nissan 200sx located
The Nissan Silvia 200SX is a three door hatchback. The 200SX has a wheelbase of 2474mm. It has a 1.8 litre engine and is available as a 5 speed manual or a 4 speed automatic.
why or how do i find the brake light switch on my 1997 nissan 200sx. how do i chane it out.
NGK Iridium, is the best set of spark plugs for 200SX
replace 1996 nissan 200sx se 1.6 tension pulley
I have nissian 200sx and want to know if I have an interference motor or not before I change the timig chain