0
either use a microfiber type or a foam roller. these types do not leave any streaks. they can be found at most lowes( whizz)
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Which type of roller is best for gloss paint?
Use a foam 100mm roller to apply paint. The go over with a good quality paint brush. the idea is to apply the paint evenly .
Which paint brush is best to use for cutting in paint along the wall near the ceiling?
The brush should be small and you should tape the ceiling to protect it but otherwise the brush doesn't matter much.
What is the best way to paint over a hard wood floor?
With a tin of paint and a brush or roller. First, be sure all of the old finish has been removed. Then prime and paint with paint specifically prepared for floors. Please note that painting a hard wood floor usually decreases the value of the property. Consider refinishing instead. Older floors were made with fairly thick boards, so they can hold up to several strippings and refinishings.
Who paints a house?
First you will want to fill all blemishes on your walls. Sand and repeat if necessary. Also be sure there is no loose paint. Scrape off any loose paint and sand smooth. Make sure your walls are clean. These steps will help ensure the new coat of paint will adhere properly.
What paint brushes look best with liquid pencil?
It really depends on what you are coloring in. If you are coloring something small then use a thin brush and if you are coloring something big then use a big brush sometimes in a packet of watercolor pencils you can find a brush.
Which type of roller is best for gloss paint?
Use a foam 100mm roller to apply paint. The go over with a good quality paint brush. the idea is to apply the paint evenly .
What is better to paint a wall with a natural brush or a synthetic brush?
Either can be used. A roller would be best to cover large areas.
What is the best paint for a pool enclosure?
Use a Exterior Latex Satin paint......You can spray on or use a zip roller low nap! You will need a brush to cut in where roller cant get.
What is the best way to paint wood without a sprayer?
Use a block brush if it is a coarsely textured wood; otherwise, a roller will work best.
Do you use brush or roller to apply kilz original primer?
If you are covering a small area, such as a patch or repair, a brush is best. If however you are priming a large area it is easier and faster to use a roller.
What is the best paint to brush on to sterling silver jewelry?
Red(:
Which paint brush is best to use for cutting in paint along the wall near the ceiling?
The brush should be small and you should tape the ceiling to protect it but otherwise the brush doesn't matter much.
What is the best way to get flat enamel paint to go on the wall without roller marks?
Thin it very slightly and use a thicker roller.
What is the best time to paint a house in Orlando Florida?
Winter is the best time to paint a house because it is the dry season and your fresh paint is less likely to be threatened by rain.
What paint should I use for metal cellar doors?
I'll suggest the best paint for a cellar door (interior or exterior) would be an oil base enamel. Before applying ensure that the doors are free of rust and peeling and rough up the old surface with a strong wire brush or coarse grit emery sandpaper. If you have cause to suspect the prior paint was a latex do not apply the oil base paint directly. You must first apply a primer. A roller will do a better job than a brush. Or you may use a spray paint.An oil base paint will serve you best to provide protection against any dampness and possible rust.
What brush to use with oil paint?
Natural bristle brushes are best when working with oil based paints.
What is the best way to paint over a hard wood floor?
With a tin of paint and a brush or roller. First, be sure all of the old finish has been removed. Then prime and paint with paint specifically prepared for floors. Please note that painting a hard wood floor usually decreases the value of the property. Consider refinishing instead. Older floors were made with fairly thick boards, so they can hold up to several strippings and refinishings.
