answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2013-07-10 10:15:52

The best or highest rated swimming pool filter depends upon the use of the pool because a high use pool needs a higher quality filter. The most popular and therefore rated highest in the popularity sense are the Pleatco cartridges.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


Yes you can order your required swimming pool filter via the internet. You can go to the website of your pool manufactuer to order the proper filter.


Yes. Running the pool filter pump while swimming has no adverse effects to the swimmers.


A swimming pool filter can be dangerous because it operates under pressure and can explode.A fastener secures the top of the filter but in some cases the fastener can fail and allow the filter to top to blow off.


Backwashing a swimming pool cleans out the sand filter. It reverses the flow to push all the trappings from the filter out.


The pool filter needs to be "back washed"


You can not measure the pressure in a swimming pool. If you mean the pressure on the filter tank gage then you may have to backwash the filter. Talk to your local pool store for instructions as how to maintain a swimming pool and the equipment. Get some education on swimming pool maint. before you get into some real trouble. A pool is not too forgiving for someone without a basic knowledge of pools.


Yes. That is how the dirt is removed.


A chlorine generator, also known as a salt generator, is an addition to a pool pump and filter system that converts salt to chlorine. It is another method of adding chlorine to a swimming pool. You will still need a filter, like sand, to filter dirt and debris from the swimming pool.


If you have a sand filter just set it on Back wash


Are you sure that you mean the filter tank? and not the pump


The cleaning schedules varies from filter to filter, but a general guideline on any swimming pool filter is to take a reading when the filter is clean, then clean the pool filter when the pressure rises about 10 psi.


That would depend on which heater model.


You may have to check the seals in the multyport on top of the sand filter.



Swimming pool pumps do not use sand. You may have sand in your filter. The sand has to by removed by hand after taking th etop of the filter off.


A pool skimmer is generally built into the side of or around the top of a swimming pool in order to skim debris from the surface of the water. A pool filter is built into the plumbing in order to filter fine debris from the water itself.


If no water is visible around pump/filter mechanism then there is a crack somewhere in the pool or pipes leading to and from pump/filter.


Add the aluminum sulphate to the pool. Run the filter for two hours. Wait overnight to vacuum the bottom of the pool.


what is the best way to prime the intex pool pump motor/filter


a swimming pool a swimming pool


It is not possible to have a pressure level on your swimming pool! However the pressure on the filter gage could run anywhere from 5# to 35#



With a strainer, simply scoop them out and/or with a filter if you have one.


No, to fill the pool just place the hose into the swimming pool and make sure not to over fill it. Hatawa


Most home pools use a cartridge type filter. These are quite adequate and filter down to the 25 micron range. If you have health concerns, you should consider a diatomaceous earth filter, which can filter out particles in the size range of most bacteria and many virus cells. This is the type of filter used on most commercial swimming pools.



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.