A punch down tool for jacks, a crimp tool for plugs.
this should be a crimping tool!
no.
RJ45 do terminate network cables. The process of wiring them requires a crimping tool and a UTP cable stripper. The former for trimming the end of the cable and squeezing the RJ45 after connecting. The latter helps in stripping the jacket of the cable.
RJ11 and RJ45 are the names for the terminators at the ends of the cables. RJ11 is the 2 pair (4 wire) terminator used for telephones. RJ45 is the 4 pair (8 wire) terminator used for ethernet cable.
A cat5 cutting stripping and crimping tool for the RJ45 male ends and a pumchdown tool for inserting the wire ends into the RJ45 female blocks. Less than $50 for the set of tools. Forgot to mention your fingers too.
Crimping tool is used.
Yes they pass through, and require an EZ-RJ45 crimp tool. They only come in bags of 100.
RJ45 female and males.
No, a conversion can not be made due to the different size of cables that each terminal end uses. An RJ45 uses a Cat , 8 wire cable where as a RJ11 uses a smaller 4 wire cable. The sockets for the RJ45 will be too wide to allow a RJ11 connector to securely connect to it.
Wire and Crimp.
No - RJ45 plugs need to be crimped, RJ45 Sockets need the wires connecting using a punchdown tool which pushes the insulated wires between the contacts and often trims the surplus wire at the same time. A better explanation is here: If you are in an absolute pinch and can't get to the store to buy crimping pliers and you have a lot of cable and cable ends upon which to practice and sufficient patience, you may be lucky enough to produce a usable cable. Don't forget to punch down the plastic strain relief that hinges perpendicular to the plug's axis on the underside.
RJ45 is used with ethernet cables in computer networking while RJ11 is used in connecting telephone units.RJ45 contains more wires than RJ11and RJ45 is physically bigger than RJ11 to accommodate the extra wires