Want this question answered?
The first fishing reel that was ever made was simply a wooden spool that usually held thread. It was attached by a basic system to a wooden pole and strung through some brass pieces of wire (eyelets) and then to the hook and cork bobber. It worked simply by thumbing the spool when a fish took the line and then twisting it (so as to retrieve your line) after the fish tired out.
if it's rusted and moldy then no if it's not, then yes
FILM!
The basic fishing tackle necessary to fish for bass includes: a fishing rod of any type, a spool of tracer with the correct strength, a hook, and a lure or bait.
Reel/real
First release the spool from the reel. Then take a length of string and tie it to the spool use a small knot keep it tidy.You then wind the string onto the spool in a clockwise direction until it covers approx 1/8 of the capacity of the spool.You then attach the nylon fishing line or braid,to the string with a small tidy knot and try hiding the knot on the outer edge of the spool.You then lift up the bail arm of the reel and refit the spool and close the bail arm.You would then load your line onto the reel until 1-3mm from the top of the spool, Be sure to wind the lines reasonably tightly.
There are two main ways of putting line onto a reel.When filling a multiplier reel it is important that the spool is filled with no line twist.When filling a fixed spool reel it is important that the line goes onto the reel the direction it leaves the edge of the spool.Very modern fixed spool reels have a twist reducing mechanism in the roller.However,it is important that the line is taken off the lip of the spool so that it rotates in the same direction as the rotor.Which everway reel is being used make sure the line that is being put on your reel is under tension. TIP Tie your line to reel , place line through a heavy book and reel the line true to your reel the book will but the line under tension and stop nests in the line.
Everyone has their favorite, but Lew's Speed Spool is the perfect cranking reel.
Try these sites:# http://fishing.about.com/od/basicfishinginstruction/a/spooling_spin.htm# http://www.wikihow.com/Keep-a-Spinning-Reel-Line-Trouble-Free# http://www.ehow.com/how_13894_load-fly-fishing.html
Spool pins are used on sewing machines to hold the spool of thread. Most or vertical, some that are horizontal use a spool cap to secure the spool of thread. Some machine come with spool nets to cover the spool to ensure the thread enter the machine evenly. Some machines come with an extra spool pin that fits into a small hole on the top of the machine to hold a second spool of thread.
First, remove the reel cover. Remove old line carefully, when you find the end, it should come off easily. Once the old line is removed, run the new through the cover, then tie the new line on the spool, and remember to remove the tag end as close as possible to the spool. Replace the cover, then reel the new line on the reel.
it uses a magnet to slow down the spin of the spool to help prevent overcast and tangles in the line. I still suggest you use your thumb to apply tension on the spool as different weight lures will make it impossible for the magnet to be sized perfectly for all application's.