Dead or weak battery? Loose or corroded battery terminals? Bad starter? Bad starter solenoid? Neutral switch?
Need to know what size engine it has.
What is the crank tork and rod tork on a 1996 Geo Tracker 1.6 Engine Block number G16A What foot pounds do they tork to??
Does the LSS have a 3.8L engine? If so, the crank sensor is behind the crank pulley/harmonic damper.
Ford rated the engine at 240 HP at the crank @ 4000 RPM.
The crank sensor sends a signal to control the spark timing to the engine. If the sensor goes bad the engine may run rough or not run at all.
where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine
The PCM (engine computer) provides the power.
They were used on the 1992 - 1996;Engine: 5SFEChassis: SXV10
Crank sensor failure. It is located on the front of the engine, points down to the crank pulley.
Crank the engine without pressing accelerator.
It is located on the lower bottom left side of the engine near the crankshaft.
It is in the passenger side of the bell housing, just behind the engine.