answersLogoWhite
Pontiac Grand Am
Turn Signals and Hazard Lights
Grand Prix GT

Why 2 minutes after driving your Pontiac grand am 1999 the turn signals and hazard signal stop working?

121314

Top Answer
User Avatar
Wiki User
2010-01-11 22:52:45
2010-01-11 22:52:45

Hazard switch is the signal relay has gone bad. Defective from new, has been replaced with a different part number.

1

Related Questions

User Avatar

If the turn signals in the dash don't work, what about the outside front and rear turn signals? Working? Not working? If it's not working, replace the turn signal relay under the dash.

User Avatar

i fnone of the turn signals work, the first placeto look is the flasher can. this is a clyander usually located in or near the fuse box. there are 2 of these.1 is for turn signals, other is for 4 way flashers

User Avatar

There's a turn signal or running light out on that side, either front or rear. Turn on signal, get out and look. If both turn signals are working, chances are its the running light.

User Avatar

run as fast as you can cause it is going to blow up in 5 minutes

User Avatar

if only the turn signals are not working,you should replace the flasher can

User Avatar

if the radio is not working in a 2007 Pontiac g6 sdn what is the problem

User Avatar

There are a few reasons why a Pontiac 3.4 liter engine may die while driving. The battery cables may of come undone, a spark plug may need changed, or the fuel pump could of stopped working.

User Avatar

Nah, it's working just fine, thank you.

User Avatar

i was driving in the rain last night my headlights and wipers quit working and i stop the car for 15 minutes and they starting working again and they are still working what could have cause this my car is 2002 cavalier

User Avatar

Turn signals just quit working- have replaced flasher- checked all bulbs and fuses, checked all obvious wires, cleaned grounds, replaced the turn signal switch (that was an adventure). At a loss- any help out there? Hazards work fine- all other lights work fine- turn signals dead

User Avatar

My turn signals are not working on my 92 buick regal.

User Avatar

Hand signals are to this day a legal form of traffic control devices.

User Avatar

If turn signals are working could be a bad bulb If turn signals are not working--could be fuse flasher or problem in steering column

User Avatar

If the turn signals are not working properly on a 2002 Chevy Venture and the fuses seem to be alright, check for burned out bulbs in the turn signals. Also, check to make sure the turn signal flasher is working properly.

User Avatar

If you are working on a Pontiac Grand Am, it is best if you have access to old parts. The Pontiac Grand Am has not been made since 2005.ÊYou can go to salvage yards and find parts for this.

User Avatar

what about it? if its on, your traction control is on & working. if its not, then its not!!

User Avatar

Your turn signals and hazards use separate flashers. Your hazard flasher might have bitten the dust. FriPilot sounds like the horn/horns arent working. also sounds like the hazard switch is inop

User Avatar

replace turn signal flasher

User Avatar

you need a new flasher, just go to the local suto store and ask them if they have a new flasher for your turn signals

User Avatar

There are a number of reasons that your signals might not be working. First off, I would check your fuses to make sure none of them are blown; next, check your bulbs. If those are all okay it might be your turn signal relay--in many car models these are located around the fuse panel somewhere, although they may not be immediately visible--also check to see if your hazard lights are working--if they are, and your fuses and bulbs aren't burnt it's probably your signal relay (note: there is one for the hazards and one for the turn signals) If your hazards and your turn signals are not working you may have a more in depth electrical problem, or both relays could be blown--however unlikely. One of the last things I would look at is the actual switch in the driving column that turns on your signals.

User Avatar

my turning signals dont work on my 91 integra LS. They were working a day before. so the next day they werent. I also had battery problems but i had checked every single fuse and the fuses arent burn. My turning signals do not work what so ever.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.