If they both have the same engine.
it will fit properly if you sawp out the headlights and front bumper from a 87-89
1985 - 1988 Nissan Maxima is the only other Nissan model with power window motors that will fit a 1986 300ZX.
Answer On the passenger side behind the kick panel....
dont....just replace it..its safer........
check vacuum lines top passenger side rear of engine
Nistune. Romulator are two of them you can use to reprogram a z31 ecu.
I have a 1988 300zx non turbo... and i have a speedometer cable that connects to the transmission as well as the speed sensor that is near the front passenger side of the car.. it is near the vacuum. its a little round thing mounted to the car with 3 wires and a cable coming out of it.
under the dash about 6inches above the brake pedal under the dash about 6 inches above the brake pedal
While it is revving that high, place your foot under the gas pedal and gently push up. If it revs down, then you need your accelerator cable adjusted.
http://www.autopartswarehouse.com/details/QQNissanQQ300ZXQQPrestoliteQQSpark_Plug_WireQQ19871989QQPRP176008.html Best bang for your Buck .
Carb.? Float sticking? Rebuild or replace
will be attached to the brake pedal where the master cylinder rod is
It is behind (and touches) brake pedal.
At the top of the clutch pedal in the cab of the truck.
On the top of the transmission next to the reverse lamp switch. Unfortunately that means it is underneath the car in the "channel" on top.
shut the door lock and then unlock it again if this doesn't work on ur model leave door open unlock trunk...
I've heard u can resolder the ground inside the control box but your best bet is to just replace it.
The evaporator is the part on a vehicle with an air-conditioning system which causes the refrigerant liquid under pressure to change to gas.
low on A.C. fluid.you may need to change the system over to 134r refridgent, to recharge the system
It is located on the brake pedal arm under the dash.
Under the dash, on the brake pedal arm mounting bracket.