It is connected so that it can disconnect the entire power grid in the house with one switch. This switch is usually integrated into a circuit breaker. No matter how one looks at it, this switch must be made to withstand (and be able to switch) great currents (in excess of 16A) at relatively high voltages (120V/230V).
Special care must be taken during the design phase, as the switch will most likely have to suffer severe arcing as well as heating, during normal operation.
that is not true your house uses a parallel circuit
In series. If they are connected in parallel then they won't cut off power supply when they switch off or when they open their contacts.
To control a light with a switch, the switch has to be connected in series with the light fixture.
Loads receive current independently of each other.
In a modern home you use parallel circuit's. The reason why they are parallel circuit and not series is For example: say your kitchen light goes off, if that light goes off the others in your house won't. They also use parallel circuit in schools. However, when there is a switch in the circuit, that switch is in series with the load, so you could say that electrical wiring is arranged in series-parallel.
Iron Clad triple pole switch
Typically they are both. Most are paralleled from the breaker and then serial from each power switch.
In series. If they are connected in parallel then they won't cut off power supply when they switch off or when they open their contacts.
Typically they are both. Most are paralleled from the breaker and then serial from each power switch.
they are not always connected in series, yes most are for circuit amplification purposes, but some SCR's are just used as an electronic switch by themselves. An example is copier circuits, they use alot of them in single use applications.
a switch brings together circuits
Switches used in electrical circuits are wired in series with either a parallel or series load. In parallel loads, the switch is upstream from the parallel circuit, so that the switch will shut off all of the parallel circuits.
No. Since the switch is in series with the circuit, opening it blocks the current flow through the circuit, turning it off.
a switch and a capacitor which is connected in series with the switch
If the switch, light bulb, and source are all connected in series and the switch is ideal (has no resistance), then the switch acts as a short. There is no potential difference across the short.
To control a light with a switch, the switch has to be connected in series with the light fixture.
The on-off switch on your nightstand, which is connected in series with the lightbulb.
House wiring is almost always parallel. Series wiring may be used for some switch circuits, however.