Headlights Tail and Brake Lights
Chevy Corvette
Ford Excursion
Ford Explorer XLT

Why are my interior lights stuck on dim can adjust lite switch to turn on but they are stuck on dim all the time is there a short its my 87 Corvette?

111213

Top Answer
User Avatar
Wiki User
Answered
2006-11-17 01:45:04
2006-11-17 01:45:04

First guess would be a bad switch.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


not to sure but on my vectra it normally controls the interior lights, but you have to pull the switch out to put the interior lights on


Headlights, interior lights, parking lights,Headlights, interior lights, parking lights,


On the interior lights for the back seats, there is a switch. When you turn the switch to "Door" mode it will make the lights turn on when the door is opened.


The switch to turn the interior light on and off on the R Reg Tigra is located on the headlight switch. Push the switch in to turn on the interior lights.


you do not adjust the brake lights check the bulbs or check switch top of brake pedal.


Check the setting on the switch


Check to see if the interior lights are switched "ON" Sometimes they get turned on when you move the headlight switch.


You probably turned them on by accident. They are controlled with the same pull switch that turns on the headlights. By twisting the switch to the far left it will click and the dome lights will turn on, by twisting it to the right it will turn off the interior lights and will then dim the dashboard lights.


The dimmer switch near/on the headlight switch is a potentiometer and it controls the dash light intensity, as well as manually turns on the interior lights at the high(bright) end.


The interior lights are controlled by the headlight switch and are protected by a fuse.


The dimmer switch is located on the turn signal switch. Pull it toward you to switch from low to high or high to low beam lights.


no it will not, because they're not connected with the same switch


In a 1997 Lincoln Continental : To the right of your headlight switch in the dash is a ( panel dim ) switch I believe if that is turned all the way up then the interior lights will come on


the switch for turning your lights on ie parking - low beam,pull it out for interior light dude....



On your light switch there is a dimmer for the dash lights . if you turn it all the way to the left your interior lights should come on , turn it to the left and see if that works otherwise it might be a door switch .


Either by opening a door or turning on the interior switch...


check the switch and make sure the lights are out. on the other hand could be a faulty interior light switch, somthing i have never seen



Beside your headlight switch in the dash is your gauge panel dimmer switch ( Rotate the switch all the way up to turn on the interior lights )


on the door there is a plastic switch on the outside edge the switch has a spring in it gets stuck you will need to try pull centre out clean it so it goesin and out then your interior lights will come onAnswerIf you have a coupe the hatch release on the edge of the door panel won't work if the also if the plunger switch located in the same area is stuck in, pull the center of the black round switch out about a half inch and it should work. Mine sticks also. hatch release


Interior Lights thumbwheel is above the headlight switch on the left of the dash. Rotate the wheel all the way up to turn on the interior lights. Just past the highest dashboard light setting.


Most often this is due to an interior light being left on. Often it is the roller switch that controls the dashlight brightness and interior lighting being set to 'interior lights on'.


If the interior lights stay on while driving on a 2002 Impala, there could be a problem with the headlight switch. Check the relay center for the headlights that is just behind the headlight switch.




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.