Brake Lights not Stop Lights. Check your Fuses then the Bulbs. Hope This Helps.
A Ford Tempo will have no brake lights if the bulb has blown or the wires have come loose. Alternatively, the brake sensor in the dash can fail and stop sending power to the lights.
Reflections in the car behind when you stop at traffic lights.
Check stop light fuse Check bulbs double filamented smaller for brake lights Check the operation of the stop light switch Check socket for corrosion
Brake lights indicate when a vehicle is about to stop. When brake lights stop working it is important to check the wiring, the fuse, and the light itself. It could be that any of those need to be replaced.
Because your brake system is not working properly. You need to have your brake system checked out and repaired before you have to make an emergency stop and then they fail to brake as they should. ALWAYS DRIVE SAFELY
The brake lights in your 1983 Nissan pickup truck are controlled by the brake light relay switch. When the brake light relay switch malfunctions the brake lights will stop working.
Check your brake lights and see if they are working. Ford has it so if your brake lights are out you can not shift out of park.
The tail lights and the stop lights work off of different circuits. The stop lights work when the brake pedal is depressed while the tail lights work when the light switch is turned on. Look for a burnt fuse or a bad connection.
check light bulbs, check stop light fuse,check stop light switch
Check bulbs - they are double filamented with smaller being used for brake lights Check stop light fuse Check the operation of the stop light switch - usually located at the upper end of the brake pedal
Check the bulbs - they are double filamented- smaller for stop and larger for tailights
After fuse (should be labeled) Try bulbs and defective stop light switch
Bulbs blown/Brake lamp switch inoperative
Because the brake lights are the priority circuit.
burnt out lightbulb!
May be stop light switch--usually located at the upper end of the brake pedal under dash
On the fuse box under the hood it shows STOP and HORN that should be for the brake lights
if turn signals are working , and brake lights not working, i would replace the stop light switch on the brake pedal
Check the bulbs - they are doubloe filamented with the smaller being for brake/turn signals Check the fuses
Possible bad stop light switch located near the brake pedal.
Check bulbs they are double filamented smaller for brake lights larger for tailights Check fuses Check stop light switch
burnt fuse ... tail lights are on a different circuit than stop or turn lights
Blown fuse, bulb, or bad brake light switch.
Check the bulbs, fuse & brake light switch on the pedal.