You may have disconnected the earth return or battery wire for the brake lights. This is only a possible solution if the brake lights do not use the frame as an earth return directly adjacent to the brake light housing. Normally the switch operated by the brake pedal or lever connects and earth to the brake circuit to light the brake lamp.
A 1990 300zx headlight is recessed into the bumper. To remove it, first loosen the headlight bracket bolts. Unplug the lights and push the housing outward. Be careful not to ruin the weather stripping for the lights.
There is one bolt on the top and three nuts behind the headlight that have to be removed.
There are 3 wing nuts holding the headlight bracket. Remove these and unplug wire going to headlight. Remove bracket from van and then the headlight can be removed from bracket.
How to replace head lights on Acura RL, 2005.
The horn is located behind the left headlight. Remove the headlight pins, and then the headlight. You should be able to spot it then.
there are two tabs on the top of the headlight that you need to pull up i the air they you can remove the hole headlight and the bulb twist out of the headlight
For the rear... Remove the plastic nuts that hold the carpet on(behind the tail lights) and then you can easily remove the bulbs For the Front... You have to remove 2 bolts (that have plastic heads that your can turn with your hand) and remove the entire headlight assembly on that side
detach the bulbs and remove the clips behind the headlight assembly
it is behind the passenger side headlight assembly. you will have to remove the headlight assembly to replace it.
Rotate headlight knob clockwise. check yer owners manual and remove the fuse behind the glove compartment.
remove the dashboard, and u will see the lights behind it
you dont unless you glue it again, if wanting to replace head lights then, on top of headlight assembly there are 2 tabs to pull up. then remove assembly.