because batteries works on the principle of electron charge and an electron can have either a more positive or negative charge but the electron wants to have an equal amount of pos. and neg. charge so when batteries are simply they pull the positive charge to one side and negative to the other side and when they come together with a conductor(wire) it creates a current which does the "work" for you. The voltage of the battery pretty much lets you know how strongly the battery wants to create equality between each side thus more current.
There is a charge "DIFFERENCE" between the sides of the battery.
To make use of that difference (For example: run your iPod) you have to connect to both sides for the machine doing the work to have the difference cause the electricity to "FLOW"
In a regular battery, there are two materials: one is positively charged, and the other is negatively charged. These materials mark the positive and negative ends of the battery.
why do batteries have a positive and a negative end?
the + side is positive and the - side is negative
so it can go to the positive side of the battery.
To the battery post with the " - " symbol not the one with the " + "
The negative wire is the one with this symbol on the battery. (-) Positive is (+)
you have to have 2 wires. then you put a wire to the positive side of the battery(+) and the other wire to the negative side of the battery(-). then both other ends to the light bulb one end to the side and one end to the bottom. you have to have 2 wires. then you put a wire to the positive side of the battery(+) and the other wire to the negative side of the battery(-). then both other ends to the light bulb one end to the side and one end to the bottom.
Generally the negative end of the battery goes up against the spring.
Hook up the jumper cables in this order: (1,2,3,4) (1) One end of positive cable to positive post of GOOD battery (2) Opposite end of positive cable to positive post of DEAD/LOW battery of disabled vehicle (3) One end of negative cable to negative post of GOOD battery (4) Opposite end of negative cable to GROUND on disabled vehicle (a good ground is preferred over the negative post, however, the cable can also be hooked to the the battery post). To remove the jumper cables after starting, reverse the order (4,3,2,1)
The proper way to use jumper cables to boost a low/dead battery: (1) one end of positive jumper cable to "dead" battery; (2) opposite end of positive jumper cable to "good" battery; (3) one end of negative jumper cable to "good" battery; (4) opposite end of negative jumper cable to GROUND on "dead" vehicle. Remove jumper cables in reverse order.
Go to the autoparts store and buy a new clamp-on end.
The nature of the chemical reactions taking place in a battery cause electric current to flow only in one direction.
Positive to positive, negative to negative if you are asking about installing one battery in a vehicle.
Negative Battery Cable Termination PointsSince I have no experience with Corvettes, this answer will of necessity be generic in nature until a Corvette expert can improve it.General Motors vehicles usually connect the "other" end of the Negative Battery Cable somewhere on the engine block.Usually this is done under one of the heavy bolts used to secure the exhaust manifold on the battery side of the engine, or under one of the bolts attaching an auxiliary bracket [as for the pollution control air compressor, or an alternator bracket.
take a small wrench and undo the positive and negative battery cables from the posts. take the old battery out and put the new one in place of the old one, and reconnect the positive to the positive post and the negative to negative.
The voltage depends on how the two batteries are connected to one another. If they are connected in a series circuit (positive end to negative end) the voltage will double. If they are wired in a parallel circuit, (It