because ur car is broke
change the temp setting on the heater a/c control head
It is at the rear of the intake manifold, follow the heater hose. there is a flow door under the dashboard with a cable connected is that the control or does the valve body at end of intake still control it?
Disconnect both heater hoses from heater core and connect them together
please tell me how to remove the heater to get too the heater coil
Sometimes, the best way to fix a heater control valve on a 1996 Town Car is to put in a new heater control panel. A used heater control panel can be found in an automobile salvage yard for less than the cost of a new one.
The heater control valve is bad. Sometimes the dual heater control valve will go and the AC will blow full heat.
It does not have a heater control valve.It does not have a heater control valve.
If your model has the digital heater/AC control panel, turn the ignition switch to "on" and then press the heater control panel's "off" and"warm" buttons at the same time for 5 seconds or so. The instrument panel will then display any codes.
If you pull the buttons off of the heater control sliders you can get a medium sized flat blade screwdriver between the edge of the heater control fascia and the main part of the dashboard, this will pop out and you will see the small bulb in its housing. Hope this helps :)
Where is the the heater control valve??
The heater control valve is used to shut off hot coolant from entering the core when the heater is in the off position. A heater control valve can be actuated by either a vacuum line or a cable from the vacuum heater control valve to the heater core. This hose should be warm; if not the heater control valve is stuck and needs to be replaced
where is the heater control valve