Normally a brake drum is turned or resurfaced using a brake drum lathe. This is usually done at a shop specializing in brake repair, or at a machine shop. Those who have a suitable metal lathe can also turn brake drums.
Brake drums can be resurfaced by turning the brake drum in a brake drum lathe. When the brake drum has deep grooves in it, it cannot be repaired.
Remove the drums and take them to an auto parts store that has a brake drum lathe.
A drum brake is a brake that uses friction caused by a set of shoes or pads that press against a rotating drum-shaped part called a brake drum. The term drum brake usually means a brake in which shoes press on the inner surface of the drum.
A drum brake is a brake that uses friction caused by a set of shoes or pads that press against a rotating drum-shaped part called a brake drum. The term drum brake usually means a brake in which shoes press on the inner surface of the drum.
there are 2 rubber plugs that pull out on the back of the drum look inside the holes and you will see the star gear, take a brake tool or a screwdriver and turn the gear upward until you feel the brake shoes rubbing on the drum as you turn the drum by hand, adjust all 4 wheels evenly.
1. Raise the car 2. Remove wheels 3. Remove brake caliper assembly 4. Remove rotors 5. Bring them to machine shop or brake inspection station where they will use the machine to reface them.
The drum and the brake shoes.
There may be a problem inside the brake drum.There may be a problem inside the brake drum.
Pretty hard to do if you do not have the tools. If you really want to have it checked, then remove the drum and take it to your local garage. Have them turn the drum only a couple of thousands to check it.
In case of cost..drum brake is better than disc brake.
there is a hole at the back of the brake/drum assembly which has a small gear in it. turn it with using a screw driver to loosen the brake grip-while turning it, try to rotate the drum from time to time to help ease out.
If the rear brakes are drum brakes remove the wheel slide the drum off and check brake lining if brake lining is good then at the bottom of the brake assembly turn the adjuster wheel out. Check by putting drum on and spinning the drum until it spin 1 to 1 1/2 times around. If the car has rear disc brakes check brake pads probably needs to be replaced