I spent many a day and dollar trying to figure that one out. Later, a mechanic friend of mine called a contact at Dodge and found ou that the computer had a know problem with the input connector. This is the connector attached to the computer, not on the wiring harness. Although, there were times that I could move the connector and the check engine fault light would come on. In the end, I had to replace the computer. I just wish Dodge had been honest about this and replaced these for free. It only fails when hot and can fail at any speed. I thought it was a safety issue and that Dodge should fix it, but they won't.
Yep had the same problem with mine. Replaced the computer (poor design by Dodge) and haven't had a problem since. There is a place online that sells reman'd ones for less then $500 and you can replace them yourselves. It's 4 bolts, a wiring harness, and 10 minutes of your time. DO NOT take it to the dealership, they'll charge you and arm and a leg
when my 1998 Dodge Durango would start and cut back off, I had to reset the alarm by using the lock / unlock buttons on my key remote.
Check the starter! It happened to my 2000 dodge durango too.
speed sensor on transmission
Misfires, hard start, no start, more often when wet.
well, theres dodge, durango, datson, daimler, desoto
sounds like vapor lock check to make sure gas line isn't touching motor it will cause it to stall or die then once cool start back up
A blown radiator hose could not cause a 2000 Dodge Durango to not have spark and not start unless the heat damaged the computer in the vehicle. Sometimes when an engine overheats, the computer that controls the firing can be damaged.
Try sitting in the seat and using the key.
Crank angle sensor or coolant temprature sensor are the two favourites that will cause a non start
Check engine light on, no start, hard start, die off.
1999 dodge intrepid is not starting I change crank and camshaft sensor and it stall will not start what can i do next.
Start rolling and reach over to the dash switch and flip it to 4h.
A Dodge Durango won't start if the battery is dead, no fuel is getting to the engine, or an electrical system failure has occurred. Due to the potentially complexity of this problem and the difficulty of narrowing the cause down, it is best addressed by a mechanic or dealership.
The red light indicates a failure in the security system. It will not start with a failure.
cam position sensor has failed
crank sensor in 2000 dodge neon fails. car starts to stall while operating. idols with no problem, when in operation starts to stall again and again until will not start again.
Does it stall at idle, just after you start up? Does it stall when you give it gas - or take your foot off of the gas? Does it stall at stoplights, stopsigns, etc? Does it stall when the engine is hot or cold or warm? I would love to try and help, but you've gotta give me something to work off of!
If a 2003 Dodge Diesel has a bad fuel pump, the vehicle will probably not start. If it does start, it will not run very long before it starts to spit and sputter and may even stall.
check your battery then the connections if it still wont start try changing the starter solenoid if possible
put the key in the drivers door and unlock the door with it
IAC its the same as the fast idle on a carb, its how comp controls cold starts **When this happened on my 1999 Dodge Durango it was a simple fix. Replace the Throttle Body Sensor. It is about 50$ at most auto retail stores.
to tune up for speed you should start with a cold air intake, a super-chip for the cpu, and buying a better exaust
See http://autos.msn.com/research/vip/reliability.aspx?year=1998&make=Dodge&model=Durango . Under "Brakes". It's probably the Rear Axle Speed Sensor. Easy Fix. Do-It-Yourself. Search this site or Google "Replace rear axle speed sensor 1998 Durango"
you have a backup so you start your backup