There is a control module in the distributor which is shot. It has a crack in it's circuit board and loses contact when hot and reestablishes contact when it cools of. It's an easy fix
what makes a 1992 gmc sonoma 5 speed tramission quit when it gets hot
Where is the timing connector on a 1995 gmc sonoma
The 1995 General Motors/GMC Sonoma has the door lock motors and actuator assemblies. These are located in the driver and passenger side doors, behind the door trims.
It is in the rear left side in a removable panel in the glovebox of my 1995 [manufactured 8/94] GMC SLS Sonoma, 4x4, 4.3 vortex; hopefully, it is in the same place in yours...
No, a 95 GMC Sonoma does not use a timing belt on it. The 95 GMC Sonoma uses a timing chain on it.
The GMC S-15 became the GMC Sonoma in 1991.
Behind the belt tensioner. It has to 10mm screws holding it onto the intake
Down the automatic transmission dipstick tube.
The torque specs for the 1994-1995 GMC Sonoma for the bolts that bolt the transmission to the engine block are 23 ft. pounds or 276 inch-lbs. This is for the S4 NV1500/3500.
will the 2.2 crossmember on a 1994 GMC sonoma fit on a 1994 GMC sonoma 3.4
The turn signal relay switch, on your 1995 GMC, is located beneath the dashboard on the drivers side. The relay switch simply plugs in and unplugs.
How do you flush the raditor on a 1992 GMC Sonoma Pickup.
where is the iat sensor located on a 2003 gmc sonoma truck
were is csp on gmc sonoma 2.2
4 and one half qts with filter change.
GMC Sonoma around 1991 - 1998 Ish,
They do this when the unit gets low on refridgerent. Which is r134-a.
what are the torque specs for a head on a 2.2 liter gmc sonoma
You need 4.5q of 5W-30 for an oil change.
I drive a 2000 gmc sonoma. My jack is behind the passenger seat in a built in box. Hope this helps.