If it is stalling when putting it into gear but not while idleing I would check your mass air flow sensor. It may need to be cleaned or replaced. If it is stalling when putting it into gear but not while idleing I would check your mass air flow sensor. It may need to be cleaned or replaced.
Possible clogged fuel filter or bad fuel pump.
do you mean you replaced the bulb? are the flashers out on both sides of the vehicle? did you check both front and back? do the lights on the dash do nothing or come on and stay on? you need to provide this information for a proper diagnosis
how bout this on the 79 there is a vacum line to the trannie connects to trannie if comes off car wont go into gear look under for lose hoses. hope this helps
Sounds like a new ignition switch is needed Sounds like a new ignition switch is needed Sounds like a new ignition switch is needed
Remove the light assy with the mounting screws.
why does my cutless ciera stall when running and starts back up
Start with replacing the fuel filter.
wher is the TPS located on a 96 oldsmobile ciera 3.1L ?
how to installing a turn light switat in 1995 Oldsmobile ciera
How do you tighten the serpentine belt on an oldsmobile ciera
Where is the signal flasher located on a 1987 Oldsmobile Cutlass Ciera?
How do you change the heater core on a 1989 Oldsmobile Cutlass Ciera? or where can I get the Info on replaceing it
what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6
The fuel pump for a 96 ciera is in the tank.
If the horn does not work on a 1996 Oldsmobile Ciera, you can replace the horn. Almost any type of horn should be compatible.
where is the knock sensor located on 93 cutlass ciera
Where is the choke sensor on a 1991 Oldsmobile ciera 3.3L