answersLogoWhite

0


Best Answer

My first thought it the fluid is overheating. You need to check if the system has a cooler installed. It may be damaged.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does power steering fluid build up pressure and come back out the cap on the pump Then it causes two cylinders to blow on the ignition coil and then the eeg fuze blows and the car will not start?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Causes of ignition key to not turn?

Worn or badly cut key, wheels turned cramping the steering wheel so that there is pressure on the key cylinder. Cylinder itself bad.


What causes a 1993 Dodge Stealth to Misfire on two cylinders?

bad coil pack on cylinders, find or pull ignition wires and you can tell by no loss of power.


What causes Isuzu trooper not to have power to ignition?

low or no oil pressure


What causes a steering wheel to freeze up you cannot move it at all when it does this It does not last long?

If you have a steering lock, that can lock your steering wheel in place, until you use the key in the ignition to unlock it.


What causes a rebuilt motor not to start?

Check the valve timing and the ignition timing. If both are good then check the compression in all the cylinders.


What causes the ignition where the key goes to lock up snd will not turn at all?

I am not sure what causes this, but I have had times when my ignition key would not turn. The solution to the main problem is to turn the steering wheel slightly. This usually allows the ignition key to turn.


What causes the engine to shake?

Not running on all cylinders? Bad spark plug or wire? Bad ignition coil (if C.O.P.)? Bad valve? etc.?


Why do car cylinders loose pressure?

because you run them to hard and it causes wear and tear. Specialy when you drive alot at high rpms it causes metal to metal.


Why could the key get stuck in the ignition?

because stupid, YOU GOT THE WRONG KEY Typically, the most common reason for the key to be "stuck" in the ignitions, is that the steering wheel is turned from the center position, which causes the ignition interlock feature to be "jammed". By manipulation of the steering wheel, to where there is no tension on it, will usually allow the key to be moved to a psoition to where it can be removed. Typically, the most common reason for the key to be "stuck" in the ignitions, is that the steering wheel is turned from the center position, which causes the ignition interlock feature to be "jammed". By manipulation of the steering wheel, to where there is no tension on it, will usually allow the key to be moved to a position to where it can be removed.


What causes intermittent loss of 1 or 2 cylinders firing in 1991 ford ranger 4cylinder cruising or at idle?

It was the dis ignition module changed it out and runs great!!


What causes squeaking when parked and turning steering wheel?

low air pressure in your tires. fill 'em up!


What causes a steering wheel to move while in park?

This means you have excessive pressure on one side of your power steering assembly. Your steering box may be worn out. Also, check your tie-rods for excessive play.