If you are using a proximity tester that senses current flow in its vicinity, it is possible that the box where the light is connected may also be used as a junction box for a separate device.
Yes. Even with no power to the light, there is still power to the switch. To power off the switch you usually need to open a circuit breaker.
the plastic part of the light switch should never show voltage especially if it's a 120 volt circuit. 240 volts is two 120 volt circuits the circuit might be connected to another circuit in the bathroom separating them will fix the voltage but you should also inspect and replace the switch. Chris Belveal
no 5v
And analog multi-tester will have a meter, battery, and switch. The meter is the part that can show the conversion of analog to digital or simply act as an analog display. The battery is the power source and the switch is the part that allows you to select the specific function of the multi-tester.
Flip the switch
WikiAnswers does not have pictures available.
You need an OBD tester to show what the problem is and to turn the light off. I believe you can lift the battery ground for a few seconds to turn the light off,but it will probably come back on.
You can use a wire tester to check for a ungrounded wire. Attached the wire tester to the battery posts. The tester will show you if the ground is weak or strong.
connectivity between host and switch can be examined by light of switch ports.
If you mean which wire goes where on the back of the light switch assembly, google MSD's free online instructions for wiring their kits It'll show the clips on the switch and the factory wire colours and where the go
1985-Power of Houston
check wiring, check bulbs, check fuse, check brake light switch,