A check engine light (Mil Malfunction indicator light) does not necessarily mean that something in the engine will break or is broken and your car will stop. It could be a malfunctioning anti-pollution device witch will not affect your driving but it WILL affect your gas mileage. There is a LOT of reason why an MIL will turn ON suddenly so it could be anything. A ROOM fuse is the fuse for the illumination of the interior of your vehicle (dome-light, trunk-light etc).
It is important to pay attention to the warning lights in a vehicle. When the check engine lights are on, it indicates a problem, and it needs to be fixed.
Usually an indication of a problem within the emission control system Have the vehicle scanned to determine the problem
It's an indication of a non specific problem in the engine and should go to the mechanic
Engine management light also known as a M I L malfunction indication light It is showing there is a problem with the engine management system on the vehicle.
No , it is not an interference engine
yes, protege 5 is 01-03 yr you can fit the protege same years for i direct swap and if you want an older engine youll nee the ecu and matching harness.
It is an indication of a engine misfire. see related questions below.It is an indication of a engine misfire. see related questions below.
Could be an indication that the engine computer has detected a problem with the glow plug system. You will need to take it in for service.
HJave vehicle scanned to determine the problem
No , the 1.8 liter 4 cylinder in a 1999 Mazda Protege is not an interference engine
You must reset the light with an OBD2 scan tool. Resetting the light without repairing the problem that set the fault code in the first place will only allow the light to come on again.
yes all the dx lx and es proteges have the same engine. atleast that year does
The oil capacity for a 2000 Mazda Protege with a 1.6 Litre engine is 2.9 litres with an oil filter change ........... it is 2.7 without an oil filter change but who in their right mind would change an engine's oil without changing the filter is beyond me ??!!
whar are the torque specs for head bolt on a 1999 Mazda protege 1.6 engine
Impossible. Rx7 is rear wheel drive and Protege is front wheel drive.
Connects air filter and engine.
A diagram of a 2000 Mazda Protege engine is available through service repair manuals. The manuals are available in either print or PDF form.
It will bolt right into the engine bay without a problem.
The ECM on the 2000 Mazda Protege is located on the backside of the engine. It is half way up above the drive shaft.
In the USA, the Protege was available as a DX, LX, or ES. The DX and LX have the 1.5L engine, and the ES has the 1.8L. In Canada, there was only the SE and LX. The SE had the DX and LX drivetrain, that is to say the 1.5L engine mated to either an automatic, or 5-speed manual transmission. The was the equivalent of the American ES model. The quickest way to identify a car packing the 1.8L engine, without popping the hood is to take a peek under the rear. The 1.8L models came with a rear sway bar from the factory, and the 1.5Ls did not. 1998 MAZDA PROTEGE 1.5L 4-cyl Engine Code Z5D 1998 MAZDA PROTEGE 1.8L 4-cyl Engine Code BP DOHC
Have the trouble codes retrieved with an OBDII scanner to identify the problem areas before you start spending on repairs that might not be the cause of the problem(s).
It is run off of the same fuse as the engine computer.
It is the center to the right of the engine...
Yes, you can if the trans is disconnected.
The Mazda Protege fuel reset button can be found on the firewall in the engine compartment. The reset button will be in the middle of the firewall.