Auto Parts and Repairs
Dashboard Lights and Gauges
Ford Expedition
Ford Ranger XLT

Why does the ABS light stay on after replacing the dashboard light bulbs in a 1995 Ford Ranger?

353637

Top Answer
User Avatar
Wiki User
2004-12-19 23:39:07
2004-12-19 23:39:07

You have a problem with the ABS system. Your brakes will still work properly but you will not have the extra safety of ABS. Have this checked out.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Bad light bulbs.... Replace them...

User Avatar

you have to remove the cover of the dashboard to replace the light bulbs

User Avatar

Yes only after replacing light bulbs.

User Avatar

remove dashboard and replace 2 bulbs behind it

User Avatar

Bulbs can be replaced you have to get bulbs type 9006 (hb4)

User Avatar

Citroen xsara Picasso dashboard light bulb is the bulb that's for the dashboard light climate control. The you tube web site gives you information as how to change the bulb.

User Avatar

Have you checked the rear bulbs to see if they are out? If not then it is probably not what that means.

User Avatar

I am replacing all of my incandescent light bulbs today.

User Avatar

Check the brake light bulbs, one may be incorrectly installed.

User Avatar

Turn on the dashboard lights, and start removing the fuses one by one. When the dashboard light turned off, that is the good fuse. If the dashboard fuse is burnt, start replacing the fuses one by one, and when the dashboard will light up that is the place of the burnt fuse.

User Avatar

MOST LIKELY... when a dashboard back light is out it's usually caused by one or more burned out bulbs.

User Avatar

This is a tedious job and static electricity can ruin the printed circuit. TAke it to a garage.

User Avatar

easiest and cheapest is to buy colored light bulbs and put in place of clear bulbs

User Avatar

The dash light dimmer switch is turned off or broken.

User Avatar

Headlight bulbs, high and low beam, parking light bulbs, signal light bulbs, brake light bulbs, dash light bulbs, interior light bulbs, plate light bulbs, etc.

User Avatar

If the rear light of a Chrysler 300m does not turn on after replacing the bulb, a fuse may be blown. Replacing the fuse should fix it.

User Avatar

What model of Corolla ? You have to take the dash board out and the bulbs can be removed and replaced from the back. The dashboard on the Corolla is not that difficult to take out, but you have to do it slowly and carefully.

User Avatar

It is possible that one of the bulbs is shorting out. Try replacing the brake light bulbs, if that doesn't work, troubleshoot the brake light switch.

User Avatar

If the bulbs light up but will not flash, the flasher relay is defective, and needs replacing. If none of the bulbs light up, the fuse is blown.

User Avatar

with the new one ! THE i said THE NEW ONE not A NEW ONE , THE .

User Avatar

One or more headlight/taillight bulbs are inoperative.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.