answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2010-06-21 03:28:58

The water is initially cold and it takes time to warm it up.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


I'm not a mechanic but did you check your water level? If your coolant is low it can't be pumped thus it overheats and cold air from the heater is another hint of low coolant level. You may have a slow leak somewhere. Hope this helped.


Weathering, orerosion, are most effectively caused by rain, running water, and by freeze/thaw cycles combined with water. In the desert it may get cold but there is little running water or rain and little water to work with freezing. As a result the most active means of erosion and weathering are absent and the weathering is slow.


they are the water works and they work slow


Plecos work well in ponds and cold water aquariums.


It works better in hot water because hot water kills more germs then the cold water does.


No water at all? from the cold side?,, Valve is off. Water is working but hot?,, The lines are connected together someplace.


Need to know if the blower is working or not or, the air coming out is cold or warm or hot or, the air (hot or cold) is only coming out the defroster.


No cold water will just give you muscle spasms and cramp


you want your cold line coming tying into both inlets on the water heaters and the hot lines tied onto the outlet side of the water heaters evenly (so they get even draw and one water heater doesen't have to work harder tnan the other). your recirc line coming in ties into the cold line in beetween the two water heaters with a circ pump going twards the cold line and the other end of the circ line tying into the hot line on the furthest fixture. on the cold line coming in you need a ball valve, check valve and expansion tank before it ties into any of the heaters. NOTE: The solution above is for tanks in parallel not in series.


no not really hot water cleans better and kills germs


Yes or no If the water is hot it can absorb cold water but it doesn't work the other way Good luck :)


On single handle shower valves, designed to let cold water first and turn handle farther to mix hot water to desired setting. If hot water turned on first, possibility of getting scalded. If seperate hot/cold handles for shower, shower valve needs work.


If you are sick, you should generally stay out of cold weather to prevent undue strain on your body. Cold weather requires your body to work harder and may slow healing or worsen symptoms.


If water is only drawn from the cold faucet, then no, the water heater is not involved. However, if water is drawn from the hot faucet- even for a few seconds- hot water IS withdrawn from the heater, and fresh cold water drawn in to be heated- even if the hot water did not make it all the way through the pipe to the faucet- and the water heater will work to heat that fresh cold water.


If the computer is too hot it will short circuit and if it is too cold it will not work properly and be very slow.


The heat of the water also helps to break down the grease.


Most laundry detergents work just as well with cold water. By using cold water you will save money and reduce environmental damage. It depends.If you are putting laundry in the washer then use hot water.If you are washing laundry that stains its colour or just washing by hand then use cold water.


Any water exercise will work but the trick is to take it slow and easy and start for only a couple minutes a day.


Tea bag will also work in cold water provided you steep it a long time than normal


The depression on the right-hand side of this figure is the bottom of the bucket. The orange tube on the top picks up the cold water coming down from the hole in the reservoir. The orange tube on the bottom is the hot-water tube (it connects to the white tube that we saw in the previous picture). You can also see the power cord coming in as well.


You forgot to pay your gas bill.........


The element at the bottom of the kettle heats the water that's close to it. This water rises (warm water is lighter than cold), and is replaced by cold water. The cold water gets heated, and the cycle repeats itself until the water's temperature triggers the kettles thermostat to switch it off.


First, check that cold inlet valve to H/W tank is open. Next remove and clean aerator on this tap. If not flowing yet, check shut off valve below sink. If none of these work time to call an expert in.


the parachutes slow down the rocket so it doesnt smash into peices when it hits the ground


Since a computer is not a liquid, it would not freeze in the sense that water freezes and turns into a solid (ice) when it gets cold enough. A computer that is not turned on will be at the temperature of its surroundings and if left in an unheated room in the winter in a cold climate, the parts of the computer may be colder than the freezing point of water. Computers, like many other machines, have optimum operating temperature ranges. If you try to operate a computer in an environment outside that range it may work poorly or not at all. If cold enough, a computer will not work well. In particular, if a computer has a liquid crystal display screen, cold temperatures will slow screen response and if the temperature is cold enough, the screen will not work at all.



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.