If the fuel gauge isn't working properly, then the problem is probably related to the fuel sending unit in the trunk. To check it, do the following: 1.Remove the trunk carpet. 2.Put some Ohmeter probes on the sending units elctrical terminals and check for resistance. 3.The first check should be done when you know the tank is full and the resistance should be about 6 ohms. 4.When the tank is almost empty check it again. Resistance should be about 1,035 ohms. 5.If the readings aren't correct, or if there's hardly a change in them, replace the sending unit. Just so you know, you can check the unit by removing it from the car and moving the float assembly manually and using the method above.
in the trunk there are 3 plastic wing nuts take them off and the light will come out.
No not with alot of work. I would suggest getting an engine from a 2nd gen car. 98-up. The 2nd gen treps didnt even come with 3.3s
i have dodge intrapid 2.7l my 02 sensor light come on p0051
1994 DODGE INTREPID..DISABLE ALARM You can't remove it. It is part of the computer progamming. You should be able to disarm it by unlocking the drivers door with a key, or with remote. If the door key doesn't turn it off, the switch on the key cylinder has come unhooked.
replace your camshaft sensor
That is the check engine light, see related question below.
It means you need to drink plenty of water and get plenty of Iron in your diet the week before and during your period.
That sounds like problem in the cluster. The high beam indicator is cross wired to the check engine light when it shouldn't be.
The light comes on when the computer detects a problem and sets a code. You need to have the system diagnose by a professional, the airbag system is not a place for do it yourselfers.
The engine is overheating.
Problem with the ABS system.
Use a socket wrench. Mine are stripped too (that is the Phillips screwdriver part). but a socket will work
Because I stole your diesel coil
A problem with the emissions system.
Use a code reader to find out why the check engine light is on.
The gas light usually comes on because you are low on gasoline and need to stop for gas.
The Chrysler Cirrus did not come out until 1995. You reset the check engine light with a scan tool or by unhooking the battery. If you have not repaired the cause of the code the light will come back on.
Probably a bad clockspring, be carefull that probably meens you're airbag is out of function too, Does the airbag light come on?
you may want to see if there has been a recall on ur vehicle on there airbags because if so it can be very dangerous for u if it is not fixed
have 1994 Chevrolet G20 van that the anti lock light comes on
Oil pressure sensor failure, wrong oil, low oil level, internal engine failure.
yes that is one of the engine options.
EGR Valve stuck open