Low oil level? Oil may "slosh" forward on hard stop causing a temporary drop in oil pressure
on the drivers side there is a fuse panel on the dash. there you need to press the reset button once and then your change oil light will blink. then you want to press it again and the low tire pressure light will blink hold the reset button until it beeps and then let go and then press the reset button again and the light should disappear. Hope this helps!
Press brakes with firm, hard pressure.
Press brakes with firm, hard pressure.
You have a wiring issue or a bad brake light bulb.
pressure through the lines try bleeding your brakes if your not sure how take it to a mechanic they will know how to and im sure they do it for under 80 bucks
Its becaue the slave cylinder is has a leak, and pressure is lost when you press on the brakes.
you have a short in light switch replace light switch
first you nee to check and see if your car is referred to as OBDI or OBDII if its ODBI then you start with the car off.. turn the key to run but do not start the engine.. at this point you have less that 5 seconds to push the gas pedall all the way to the floor and press the overdrive button five times... then the check engine light will stay on.. and then blink... next its going to blink out the code for you for ex. blink-pause-blink blink-pause blink blink blink-pause blink n that would mean the problem code is 1231 just Google BMW problem codes and use that dcode to find out what the issue is..
To change the code on Youniverse safe, press the enter key on the display screen. Red light will blink and the current code will be displayed. Input the new code and press enter.
Just press the reset button at the fuse panel on the driver side. Press it for some seconds and it will clear the light.
There is a button under the steering wheel press it in for about 5 seconds and the light will go out. Then your tire pressure is low it will light again check your tire pressure inflate then push the button again.
Might be a bad wheel bearing assembly