Buick Riviera
Ford Explorer XLT

Why does the ses light comes on and off what should you do to fix this on a 1995 Buick Riviera?

838485

Top Answer
User Avatar
Wiki User
2004-09-03 20:34:45
2004-09-03 20:34:45

The code 41 can be things other than the cam sensor. It's a good bet this is your problem. There is a magnet on the cam gear. It's there to trigger the cam sensors its location to the engine management computer. They can fall out and set the cam sensor code. It's a big job and you need to remove the timing cover and replace the magnet. Good luck

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I have a 1986 Buick Riviera that the same thing happened to and it turned out to be a fuse blown on the GCC CRT unit. I went ahead and bought a used CRT from a junkyard for about .00.

User Avatar

I own a 1996 Buick Riviera and the check engine light started flashing.I noticed a slight loss in acceleration.Could this be bad gas,a clogged fuel filter,or the spark plugs and wires may need changing.Help me.

User Avatar

I'm looking for help.The secority light is on car won't start.

User Avatar

I've got a better question, why is this question in the Chevy venture forum ?

User Avatar

Under the driver side dash. There should be a panel just to the left of the brake. The fuses are inside the panel quite a bit, you might need a flash light to see.

User Avatar

you have two buttons under the head light switch one will do the job if broke use tooth pick

User Avatar

There are several reasons why an AWD light comes on in a Buick Rendezvous. A few reasons could be burned oil, gear oil is hot, or even a burned out clutch.

User Avatar

My 98 riviera was doing the same I put some stp complete fuel system cleaner and it stopped happening might be worth a try it was only $9

User Avatar

what u could do is take then to a garage so u cold get them changed or smash em that's wat i would do=)

User Avatar

its the sencor in the blinker plan on spending $500 or more part and labor they have to remove the steering wheel

User Avatar

As soon as the 2003 Buick Regal change oil light comes on, it is important to do so immediately. Not changing your oil can damage the motor in your car.

User Avatar

The 2001 Buick Century brake light switch is located beneath the dashboard, on the drivers side. The brake light switch should be labeled as such.

User Avatar

You will need to remove the inner trunk liner to access the mounting bolts. The entire rear light panel will need to be removed as one unit just to replace one bulb.

User Avatar

The low tire pressure light on a 2002 Buick Century is reset by pressing the red button in the passenger fuse box. The light will return if the pressure problem is not fixed or if the leak comes back.

User Avatar

I have a '96 Riviera and if they have the sensor for nighttime driving like mine do you cannot drive with the lights off if it is dark, but you can push the knob bellow the light switch all the way to the left where it says Lights Max or something like that. this will turn the lights off while car is in Park, at night otherwise the lights should stay off in the daytime

User Avatar

What should you do when the enigne light comes on in the nissan altima 1996 and how should i go about fixing what does it need?

User Avatar

The low traction light comes on in the 2003 Buick Century if the road is icy or if the road is wet. This is a warning light to let the driver know to slow down. If the light is coming on for no reason, the tires might be the problem. Bald tires can cause this light to come on.

User Avatar

Should have an access panel inside trunk

User Avatar

Where is the backup light switch on a 2002 buick century?

User Avatar

I have a 97 SC and it is located between the firewall and engine on the drivers side of the car. It is low down on the engine on that side. Hard to see in poor light.

User Avatar

how do you reset check engine light in 2008 buick lucerne

User Avatar

You better check the computer code ASAP it may let you down on the road. Mine did.

User Avatar

open trunk there are six hand tightened plastic wing nuts undo all of those the entire assembly will come off then you may change bulbs


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.