It is your relay in the distribution box. I had the same problem. I cant remember which one it is but get your owners manual and just swap it with another relay.
When the windshield wiper on a 2000 Ford Ranger comes on by itself this can signal a damaged windshield wiper switch. Changing these switches out often corrects this problem.
auto zone
The 1998 Ford Ranger takes 18" replacement windshield wiper blades on both sides front.
On most Escape, there is a small wheel below the main windshield wiper knob. It should have settings 0,1, and 2, along with a spray setting.
It's in the fuse box on the left drivers leg, under the dash area.
How do I replace the windshield wiper switch?
There was an inventor (of the windshield wiper) called Mary Anderson.There was an inventor (of the windshield wiper) called Mary Anderson.There was an inventor (of the windshield wiper) called Mary Anderson.There was an inventor (of the windshield wiper) called Mary Anderson.
Replace the locking tab on top of the wiper
Remove the windshield wiper arm from the windshield wiper motor. Remove the wiring harness. Remove the retaining nut. Reverse the process to install the new windshield wiper motor.
The windshield wiper control module is usually in the fuse box located in the engine compartment of most automobiles. Sometimes the windshield wiper control module is located on the firewall next to the windshield wiper motor.
The wiper blade misses the windshield in the middle of the wipe. Is there an adjustment for that ? I have replaced the wiper to no avail.
Please clarify or explain what you are trying to accomplish. There are no dip switch setting on that wiper motor that I have ever seen.