answersLogoWhite

0


Best Answer
Copy

Check the Transmission Fluid level and condition. You may need to replace the filter and flush/fill it. It could also be the valve body. 94-96 Berettas with the 3100 V6 only came mated to the 4T60-e automatic transmission. This transmission is not prone to the torque converter clutch solenoid lockup syndrome that the previous 3T40 transmission was known for. Unplugging the solenoid will likely do nothing to remedy the problem.

2009-08-03 19:42:01
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

How do you remove the pins that hold the hoses in place on 1993 Chevy Beretta slave cylinder?

Take a punch and push the pin through as far as you can, then twist it out with a pair of pliers


Where is the fuel pressure test port on a 1995 Chevy Beretta?

There is no schrader valve, you need to source an adapter to place between where the fuel line attaches to the intake manifold.


How many minutes do it take if you drive 40 mph to get to a place that is 60 miles?

1 hour 30 minutes


Where can i buy Beretta model 1200 barrel?

Beretta would be a place to start, then want ads, gun shops, gun shows


How does the fwd on 1993 Chevy Silverado work?

First while your in drive, place the truck into 4wd from 2wd. Then place the truck in neutral. Make sure the truck in in 4wd. Put the truck back into drive and that's that.


Can you use short shaft transmission in a Chevy truck turbo 2 wheel drive pickup in place of long shaft transmission?

You can but you will have to change or alter the drive shaft also.


Can a Chevy Silverado 4 wheel drive be towed behind a motor home?

Yes. Your owner's manual will tell you how to place it in neutral.


Why doesn't a 1995 Chevy Beretta shift into first gear?

I have the same problem...its really hard to shift into first so we turn off the beretta then shift it into first but it usually makes a reall annoying sound when we start it and we bolted it into place with a bolt but it still runs like it does and its very nerve racking when driving in town! please find this answer!


2005 trailblazer 4.2 engine can you drive without the air box cover in place?

You can drive your 2005 Chevy Trailblazer 4.2 liter engine with salt the air box cover in place. It is not recommended to do so, because cost particles can get into your engine.


What Took The Chevy Corsica's Place?

The Chevy Malibu


Where is the crank sensor on a 1989 Chevy Beretta and how do you fix it?

the crank sensor is located on the back of the engine aprox. 1 inch above the oil pan. there is one bolt holding it in place, after removing the bolt pull the sensor out installation is reverse


How do you replace the fuel filter on a 1996 Chevy Beretta?

the fuel filter on a 96 beretta is on the driver side in the rear underneath. it is about as big as the oil filter and is silver. it is easy to take off. The fuel filter in my 96 Beretta is on the passenger side in the rear of the car right above the axle. It's also big and cylindrical. Someone suggested that you first start the car and shut it off in gear. That way, there won't be as much pressure in the gas line and leak all over the place. Suggestion: be prepared for gasoline to leak out of the lines. Do in well ventilated place or outside.


How will you get from place to place on Mars?

you will have too drive from place to place too get around mars :~)you will have too drive from place to place too get around mars :~)


Where do you add transmission fluid in a 94 Chevy Beretta?

If it is an A/T you add through the same place you check it. If it is a manual transmission, you add underneath the car on the side of the trans. This information can be found in your owner's manual. Don't have one, get one. Dealer or salvage yard is a source.


How do you remove the glove box lock on a 1968 Chevy Nova?

after the glove box is open there is a nut that holds the tumbler in place just un screw it drive safe


When was Matt's Place Drive-In created?

Matt's Place Drive-In was created in 1930.


Where do I place the jack to jack up the front of a 1994 Chevy cavalier?

It is easier to just jack up both sides of the car separately, or drive the car up on ramps.


Where should you look to disable an alarm on a 98 Chevy blazer?

take it to a Chevy place


Where can you find after market parts for your 1994 Chevy beretta or custom parts?

With the advent of the World Wide Web, almost everything is now available at the click of a mouse! If you are looking for custom or aftermarket parts for your Chevy Beretta, I suggest logging on to the Internet and finding the best deals available. Since it's such a competitive market, you are likely to get some great offers on car parts of your choice. In fact, aftermarket car parts supplier 1aauto.com claim that their parts are often available at 1/3rd of the dealer price. I think that's a good place to start searching for your Chevrolet aftermarket parts.


What is a drive-in?

A place you get to in your car.


Is the Chevy Traverse safe to drive?

The Chevy Traverse is safe to drive as it has passed all the statutory safety requirements in order for it to be sold in the first place. In addition, it has been a top 5 Safety Pick by the Insurance Institute for Highway Safety (IIHS) and has achieved rare 5-Star overall crash worthiness rating from the National Highway Traffic Safety Administration (NHTSA).


How far from Calgary to fawson creek?

It is 884 km from Calgary to Dawson Creek, Canada. It would take 8 hours and 21 minutes to drive from one place to the other.


How long does it take to drive from milan to Venice?

The distance from Milan to Venice in Italy is 272.4 km. How long it will take to drive from one place to the other is dependent upon road conditions but the average journey time is 2 hours and 55 minutes.


How do people in France move from place to place?

they can drive or fly


Why do you drive a car?

to get to place to place in an efficient, lazy way