It means that the ABS control module has detected a problem in the ABS system. That will be impossible to determine without talking to the module with a scan tool to find out why it turned the light on. The other thing that it means is that you do not have ABS, but you now have conventional brakes. The ABS part of the brakes will not work until the problem is found out and fixed.
Check the fuse first...start simple and cheap.
Wiki User
∙ 2018-04-27 15:51:51check brake fluid level.
DOT ( 3 ) brake fluid , if that is what you are asking ?
No,a transmission on a 2005 mercury mountaineer will not fit on a 2000 mercury mountaineer unless you change the oil message on the mountaineer.
No , a 2000 Mercury Mountaineer is body on frame
yes the is a single assembly. replacement assembly is available here http://www.doctorautoparts.com
According to the 2000 Mercury Mountaineer Owner Guide : ( Yes , DOT 3 brake fluid , meeting Ford specification ESA-M6C25-A )
The red " BRAKE " warning light in your dash comes on if the emergency brake / parking brake is on , or if the BRAKE FLUID LEVEL in the brake master cylinder ( located in your engine compartment , near the firewall , on the drivers side of the engine compartment ) IS LOW
The engine is fuel injected so there is no carburetor on a 2000 Mercury Mountaineer
Because your switch is bad, replace the light assembly
The Mercury Mountaineer has hydraulic brakes, not air brakes.
Fuse # 17 is a 25 amp fuse for the cigarette lighter in a 2000 Mercury Mountaineer
firing order for 2000 mercury mountaineer with a 4.0, v-6 engine