No fluid in the master cylinder
Clutch safety switch =- should be on the top of the clutch pedal under dash area Neutral safety switch could be at the lower end of the gearshift handle or at the side of the transmission
No pressure in clutch resevior, its next to the brake resevior, if its empty, put more, if not you have a leak.
At the top of the clutch pedal in the cab of the truck.
You have a broken clutch.
clutch pedal over -centre spring pressure
turn your car on and pump the peddel with your hand till u get pressure then get a new clutch and master cylinder for the clutch
When you engage the clutch and the engine sits there spinning: it get's no traction OR when there is no pressure on the clutch pedal: pressing it changes nothing.
Clutch master cylinder might be blown out. this is located in the engine bay, the top right.
The pressure plate which forces the friction disc against the flywheel by means of spring plates. Pressing the clutch pedal down forces the pressure plate away from the friction disc and power transfer from engine to transmission is broken.
It may be as simple as an auto adjustment. If you have installed a new clutch/ clutch cable. If it is auto adj all you have to do is lift UP on the clutch pedal with your foot while driving.
You may have some bare wires that are shorting out on the clutch pedal. Get under the dash and check it out.
The relay is H270 above the fuse block next to the clutch pedal.
You will eventually lose clutch pedal pressure and the car will refuse to shift into gear.
I believe you can but normally when it engages low its a sign that the clutch should be replaced soon.
No.... There is not an adjustment what so ever. You either have a bad clutch slave cylinder / clutch master cylinder. Are the clutch and pressure plate are worn out.