answersLogoWhite

0

Headlights Tail and Brake Lights
Chevy Suburban
Ford F-150
Turn Signals and Hazard Lights

Why don't your brake lights and turn signals work on your 1994 ford club wagon?


Top Answer
User Avatar
Wiki User
Answered 2009-03-21 20:15:26

check the fuses.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

1994 Chevy silverado all 3 brake lights and tail lights don't work but signals do?

if the tail lights work but not brake lights then its most likely just a blown fuse or it could be the switch at the top of your brake pedal arm.


Why would the brake lights on a 1994 Volvo 940 wagon stop?

Check the bulbs, check the fuse, check the brake light switch, in that order.


Why do the signals brake lights and front hazard lights on a 1994 Mustang work but not the rear hazards?

The multifunction switch inside the steering column is bad.


Why do the turn signals work on a 1994 Jaguar XJ6 but not the brake lights when it's the same bulb?

There are two elements in some bulbs. One element is for the tun flash, the other is for the brake or taillight. I also failed to mention that they are single element bulbs. It's 1 bulb, single element. It controls both the brake light and the turn signal. The turn signals work fine on both sides but no brake lights when I apply the brake.


HONDA 1994 brake light in dash stays on checked brake lights there are okay?

check brake fluid


Honda Civic brake lights stay on?

Brake light on 1994 Honda civic staying on.


No brake lights turn signal or hazard lights in a 94 Honda Civic?

Your problem very well could be the hazard switch. i have a 1994 honda civic too i found whenever i disconnected the hazard switch from the wiring harness my turn signals brake lights and of course hazards do not work. Maybe replace the hazard switch..


On a 1994 Buick Roadmaster wagon no dash or tail lights fuse keeps blowing has new switch Now fuses don't blow but still no lights what else could be wrong?

Check your tow bar and trailer brake light wiring. It may be grounded. I had this problem with my 92 roadmaster wagon. Tom.


Why would brake lights and rear turn signals not work in 1994 Ford Taurus?

Check the Fuses real quick. If not it could be related to a computer issue... Thanks Ford lol


Why do your hazard lights on your 1994 metro work but not your turn signals?

Turn signal flasher?


What causes brake lights of 1994 Toyota Corolla to remain on?

Defective or mis-adjusted brake light switch


Where is the relay that control brake lights on a 1994 Oldsmobile CS Coupe?

There is no brake light relay. There is however a brake light switch located above the brake pedal.


94 dodge Intrepid brake lights stay on when car not running?

If the brake lights stay on when the car is not running on most vehicles, including the 1994 Dodge Intrepid, there is probably a short somewhere in the wiring to the brake lights. The first place to investigate this problem would be the wires along the firewall that control the brake lights. Also, check the brake light switch above the brake pedal.


Your brake lights will not work on a 1994 ford escort you have already replaced bulbs and fuses?

Working brake lights are important for safety reasons while driving. It is important to check all of the wiring, if the brake lights are not working and the fuses and bulbs have been checked.


What fuse controls the back lights on 1994 Jeep Grand Cherokee?

It should say TAIL for taillights or maybe brake lights.


Brake light switch sticks 0n 1994 Chevy blazer keeps brake lights on until you move brake pedal?

Brake Lights Stay on Unless the Brake Pedal is RaisedThis is usually caused by the brake light switch being out of adjustment in its physical distance to the contact point on the brake pedal arm.


What would cause the third brake light not to work but the other brake lights do in a 1994 s10 pickup?

a blown bulb or loose wire.


Show diagram of 2002 GMC Yukon Fuse box?

1994 gmc no brake lights 3 brake light works need help


Why don't my 1994 Chev 3500 brake lights work?

it is broken Check the fuse, check the bulbs, check the brake light switch, in that order.


If the switch activated by your brake for your 1994 Nissan sentra brake lights and tail lights is broken and your lights stay on when the engine is off how can you fix it?

There is a switch just above the brake pedal that is called the brake stoplight switch. When the brake pedal is released, it stops the brake lights from illuminating. Check to make sure the switch is contacting the brake pedal stop where it should. A short term method of not killing the battery would be to unplug the connector to the switch and get a new one. It won't have brake lights when disconnected so I don't recommend driving with it like that. replace the broken switch


Why would the turn signals and hazard lights on a 1994 Toyota Corolla not work?

check the fuses and then check the flasher relays


Why would the hazard lights not work after replacing the turn signal arm mechanism on a 1994 Eagle Summit station wagon if the signals do work?

the hazard lights and turn signals are linked together. make sure your signal arm is entirely linked up to all of the wires it should be. make sure no wires fell down that you didn't notice when the turn signal switch was pulled. you can also check the hazard switch.


What can cause my taillights on a 1994 gmc 2500 pickup not to work even though the brake lights and turn signals work?

The tail light circuit is separate from the brake and signal light circuit. So, check the fuses, check the bulbs, check the sockets and if you haven't found the problem yet, check the wiring.


How do you trouble shoot a brake light problem in a 1994 GMC jimmy All lights will work but brake lights?

AnswerCHECK BRAKE LIGHT SWITCH UNDER DASH LOCATED JUST ABOVE BRAKE PEDAL.there is another switch next to arm on the brake peddle that slides up and down when you work the peddle . mine was loose


Brake lights don't work on 1994 Chevrolet diesel but the turning and clearance lights work?

You have a bad ground to the from the glow plug relay to the engine block