I don't know but it also happens on my 2000 Camry.
The neutral safety switch on a 2002 Toyota Camry can be found in the driver side footwell. A neutral safety switch prevents a standard car from starting without having to press in the clutch and are mounted behind the clutch pedal.
If the engine is running it is burning fuel, whether the gas pedal is pressed or not.
It's located very close the brakes pedal mounting.
Check rear bulbs, rear brake bulb fuse, and check the swith on the brake pedal.
A dashboard light appearing when brake pedal is depressed usually means brake fluid is low.
Control cable worn? Bad throttle body assembly?
When You Drive A Old Skool Car With A Carb You press down the pedal for cold starts but when car is warmed up you don't always have to press down the pedal Sometimes you need to press it down in the morning becoause of the condensation. //////on a car with a carburetor you need to press the gas pedal when starting cold to engage the choke and also the fast idle cam
Usually at the upper end of the brake pedal under dash
brake light swith located under the brake pedal is stuck.
On a 97 Toyota Camry, the flasher relay is typically located under the dash. When the dash is opened, the flasher relay will be right under the gas pedal.
One of the main causes of feeling a vibration in the gas pedal is engine vibration. The vibration from the engine causes the accelerator cable or linkage to vibrate and the vibration can be felt in the gas pedal. Check with a mechanic to be sure.
do not take dash apart follow brake pedal upward and look for a switch that opens when pedal is depressed that is the sls.
Use WD-40 or Deep Creep from Seafoam and spray in the tube where the gas pedal cord goes in. Do it from both sides: from inside the car and from the engine compartment.
you will most likely need to change the spark plugs
brake boster is bad
The 1990 Toyota Camry turn signal flasher relay switch can be found beneath the drivers side dashboard. The turn signal flasher relay switch will be above the gas pedal.
Check the switch at the brake pedal .
Try cleaning the MAF (Mass Air Flow) sensor. Use MAF sensor cleaner only and follow directions on the can.
Brake system has air in it.
Trouble code P0121 means:Throttle/pedal position sensor/switch A circuit range/performance problem
Take your toe and pick UP on the brake pedal. The brake pedal may not be returning as it should.
there is a travel limiter on the pedal. turn it the right way.
Normally you don't touch the gas pedal , just turn your ignition key
A 1995 Honda Accord clutch pedal switch is located directly under the clutch pedal. This switch stops the car from starting with depressing the clutch. This helps avoid accidents.