Wet Mount Slide Steps
1. Place a sample on the slide.
2.Using a pipette, place a drop of water on the specimen. Then place on edge of the cover slip over the sample and carefully lower the cover slip into place using a toothpick or equivalent.
*This method will help prevent air bubbles from being trapped under the cover slip. Your objective is to have sufficient water to fill the space between cover slip and slide. If there is too much water, the cover slip will slide around. Take a piece of paper towel and hold it close to one edge of the cover slip. This will draw out some water. If too dry, add a drop of water beside the cover slip. Practice this until you get used to it.
Staining Steps
All you have to do is get a yellow stain and just drop one drop and it should spread throughout the water and should turn that color.
Place slide on stage and stabilize w/clipsCenter slide on stageLowest-power objective lens is in placeDecrease between stage and tip of objective lensFocus with coarse and fine knobs
Place slide on stage and stabilize w/clipsCenter slide on stageLowest-power objective lens is in placeDecrease between stage and tip of objective lensFocus with coarse and fine knobs
you have to do six steps
six steps
I counted 225 steps
the five steps to making a wet mount slide is 1.use a flat glass slide to prepare a wt mount slide 2.suck up a few drops of water from your liquid specimen into a medicaine dropper 3.pick up the wet mount slide on the 2 outer sides of the slides 4.place the specimen your using into the water 5.place the top cover slips on the top of the water with the specimen in it (: (: (: (: (: (: (: (: (: (:
You need the bottom of the the slide, the you put a specimen on it. After put a drop of water on it then put the cover and apply pressure.
Actually, both methods are used during the staining procedure (steam & heat fix). Initially, the organism is heat fixed to the slide to prevent the organism from being washed off during subsequent steps. Later in the procedure, the slide with the heat fixed organism is steamed to make the cell wall a little more penetrable - allowing the stain to enter the cell wall.
With periodic acid during the steps of staining slides.
You will have to climb 264 steps to ride The Verruckt slide.
Preparing for a dry fast involves taking certain steps before beginning your fast
hi guys
No, the microorganism needs to be heat fixed onto the slide so it doesn't wash away with all the wash steps. The wet part refers to the liquid that is placed on the fixed cells before the cover slip is put on.
2 steps and look up 'how to run a slide on ms powerpoint' on here to see what they r
slide...cut....cut........
slide-cut-hop
There are following steps are invoved in prepration of drug for commercial market;CultivationCollection.Harvesting.Adulteration.Drying.Garbling.Packing and labeling.Storage.Preservation.