answersLogoWhite

0


Best Answer
Answer

timing out of adjustment. start with distributer timing and go to timing belt or chain

could be the crank position sensor located behind the harmonic balancer

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why is my oldsmoblie cutlass cerria backfiring and not starting?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why is your oldsmoblie cutlass cerria backfiring?

More than likely it is out of time. Have the timing checked. If you have changed the plugs or plug wires, you have them hooked up wrong.


How do you find a fuel relay switch on Oldsmobile cutlass cerria?

over there


Which steering column is interchangeable with a 1991 olds cutlass cerria?

the best way is too call a big savage yard they can tell you what parts interchange for sure instead of people guessing on here


Where is the transmission drain on a oldmobile cutless cerria?

If it is an automatic you have to remove the pan


How do you replace the water pump on a Oldsmobile Cutlass cerria 1991?

maybe this will help,,, i just replaced the water pump,heater core,thermostat,battery,alternater on my Oldsmobile and found this site to be very helpful even has pictures AutoMedia.com maybe you can find your answer there good luck


How can you check on a 1990 Oldsmobile Cutlass Cerria SW 6cyl fuel injected for an electrical short on the battery when the car is not running?

Disconect the negative terminal & put a test light in line-& start pulling fuses until the test light goes out.when U get 2 the fuse that turns out the test light-THAT is the Circuit u start 2 trace.make sure the light is inlne-NOT having the battery cable touching the battery post.just the light - inline.


What are the procedures to remove the 1991 olds cerria Drivers door to raise-balance door so latch hooks properly?

When a door drops down it usually is bacause it needs a hinge bushing. However, if everything's OK there's two things you can do. 1. Easiest method. Put a jack underneath the door and bend it back up. Unless the hinge has slipped, that's why it's down there anyway. 2. If applicable, loosen the hinge and adjust the door up.