answersLogoWhite
Ford Escort LX
Car Electronics and Lights

Why is the dome light not working. I replaced bulb but it is still not working?

Be the first to answer!


Related Questions


If the trunk light bulb still isn't working, it may need to be replaced. Also, check to see if the problem is a blown fuse.Ê


If it is working and produces light, then it is a source of light.



No. I am assuming that you first replaced the bulb? If you did replace the bulb, then I would check to see if you are getting power to the bulb socket. If no power is getting to the socket, you then need to find the break in the electric lines going to the socket.


There are two filaments in a stop/tail bulb. If one burns out it is possible for the other to still function. The bulb will still need to be replaced.


A reverse light bulb is not working.A reverse light bulb is not working.


On a 1994 Honda Accord, the brake lamp comes on when a tail light is no longer working. The burned-out bulb needs to be replaced. The brake lamp will not come on after the bulb is replaced.


A turn signal not working on a 92 Chevy Lumina may be out because of a burnt out bulb. If you replace the bulb and it is still not working, the turn signal switch may need to be replaced. You can get the switch replaced by a mechanic.


the first light bulb was created over 200 years ago but sadly the light bulb stopped working when a stanger took the light bulb from the museum 20 years ago.



If one light bulb in a series circuit fails, all the other light bulbs will go out, until the failed bulb is replaced and the series circuit is completed again.If one light bulb in a parallel circuit fails, all the other light bulbs will still work.


There could be a switch that has gone bad in the headlight. The entire assembly will more then likely need to be replaced.


If it still doesn't burn, check the ground of the light assy.


Same thing happened to mine. I had to replace the whole thing. Mechanic told me it was due to a nonworking electrical wiring that was connected to the brake lights were out. Once you replaced the whole thing, it should be working.


A light bulb turns electrical energy into light and heat energy.


the main reason for a light bulb to break is, the light bulb heats the tungstin wire. When the tungstin wire gets heated to much it breaks, causing thi light bulb to stop working.


If your light bulb is good, then it could be a wiring issue or a fuse issue. A fuse is cheap to replace, so start with that first. If after replacing the fuse, your headlight bulb is still not working, try a good bulb with your adapter. If it doesn't work, then it's wiring issue.


How do i remove the tail light on a 2005 Honda odyssey to rpleced the light bulb.


There is a small metal the grabs the bulb connection in place. If it is worn out the bulb becomes loose with vibration. Have it checked and replaced in auto parts store.


You need to change the bulb. The filiment for the brake light part of the bulb is "open" or burned out. The filiment for the tail light portion will still work.


The bulb could be 'blown'. Remove the working bulb from the other light and try it in the socket of the one that isn't working.



my light on the odometer is not working anymore how do you replace the bulb on it


it does for a split second then it just...stops working forever hahaa




Copyright © 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.