Fuel and Engines
Buick Skylark
Ford Explorer XLT
Ford F-150

Why is the engine running at a fast idle of 1800 to 2000 rpm warm or cold on a 1997 skylark?

131415

Top Answer
User Avatar
Wiki User
Answered
2007-03-25 01:41:39
2007-03-25 01:41:39

It could be either the temperature control sensor to the computer, or the ambient air sensor.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


picture diagrams of engine for 1997 buick skylark

If you mean the engine, yes. The actual car, no.

I have a 1995 Skylark and the gasket was replaced about 4 years ago and I've had no trouble at all. It's a V-6 3100 engine.

Remove belt and tensioner should just be bolted to engine

I think it will... but try contacting a GM dealer's service center to make sure. (Do it before it becomes Government Motors instead of General Motors).

where is the blower motor resistor located on 97 buick skylark

Just follow that top hose leading to the engine. Remove that metal pipe attached. It's right there.

SHOULD BE THE BELT DRIVEN ACCESSORY DIRECTLY ABOVE THE CRANKSHAFT (LOWEST BELT DRIVEN ACCESSORY ON ENGINE)

Front right corner of engine compartment(facing carfrom front) !Filler cap should be in plain view.

The 1997 Buick Skylark computer is located behind the passenger side dashboard. You will need to remove the passenger side kick plate in order to access the computer.

Check for proper fuel pressure in the 1997 Talon. The engine appears to be starving for fuel and only has enough pressure to start.

It is possible that the fuel line in the 1997 Buick Skylark is bad. Getting a tune-up or changing the fuel filter may resolve this problem.

On the 2.3 Quad 4 Skylark engine the power steering pump is at the front of the engine block behind the radiator, Usualy where you would see the oil dipstick. The cap should say power steering fluid. Check the dipstick that is on the cap, and fill until the dipstick reads full.

When owning or driving a car, it is important to know the cars gas tank size. The 1997 Buick Skylark has a gas tank of 15. 2 gallons.

The oil pump is mounted to engine motor and is located to right front side (in this transverse mounted engine application). The replacement oil pump is Sealed Power #22443573.

Exhaust Gas Recirculation Flow Insufficient......

Try Crutchfield.com for installation kits.

Not sure about a switch, but there is a fuse for it in the fuse box.

The V-6 is a 3.1 litre. There's also a 4-cylinder available but I don't know the size. The 4-cylinder motor size is a 2.3


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.